PAH 1700 A1
GB
│
IE
│
NI
│
5
■
5 . Service
a)
Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts.
This will ensure that the safety of
the power tool is maintained .
Safety instructions specific to hammers
■
Wear hearing protection.
Exposure
to loud noise can lead to hearing loss .
■
Use the additional handles supplied with the
appliance.
Loss of control can lead to injuries .
■
Hold the appliance by the insulated handles
when you are carrying out work during which
the deployed tool may come into contact with
concealed power cables or its own power
cable.
Contact with a live wire may electrify
exposed metal parts of the power tool and
could give the operator an electric shock .
■
Wear a dust mask.
Before use
WarnInG! rISK of InjUry!
►
Switch off the appliance and pull out the
power plug before starting any work on the
appliance .
NOTE
►
Periodically check the tightness of the hexa-
gon socket head screws on the unit . Use the
included hex key .
Greasing
WarnInG!
►
Before every use, check whether there is
enough grease (e .g . multi-purpose grease,
bearing grease, etc .) in the appliance and
on the chisel . Operation without grease will
cause irreparable damage to the appliance .
♦
Grease the tool holder with the supplied
grease .
♦
Grease the appropriate chisel shaft /
with the supplied grease .
Checking the oil level
NOTE
►
Before operating the appliance, check whether
there is enough oil (e .g . SAE 20W—50) in the
appliance . Operation without sufficient oil will
cause irreparable damage to the appliance .
♦
Hold the appliance with the tool holder
facing upwards .
♦
Look in the oil inspection window on the
underside of the appliance to see whether there
is sufficient oil in the appliance (see fig . 1) .
Fig. 1
If you cannot see any oil in the oil inspection
window , top up the oil (SAE 20W—50) as
described in the section “Topping up the oil” .
Mount the auxiliary handle
The additional handle is not mounted on
delivery .
♦
Mount the additional handle as shown in the
exploded view (see fold-out page) .
Use the additional handle
♦
You can position the additional handle as
you wish .
♦
Undo the knurled nut .
♦
Turn the additional handle around the ap-
pliance axis and/or up to 360° forwards or
backwards into the desired position .
♦
Retighten the knurled nut .
IB_285765_PAH1700A1_LB6-.indb 5
03.05.17 15:29
