27
GB
charging�
z
Risk of leakage from
batteries/rechargeable
batteries
Avoid exposing batteries/rechargeable
batteries to extreme conditions and
temperatures, e�g� on radiators/in direct
sunlight�
Avoid contact with skin, eyes and mucous
membranes! In the event of skin contact
with battery acid, rinse the affected area
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
Leaking or damaged batteries/
rechargeable batteries can cause
chemical burns if they come into contact
with the skin� Therefore, wear suitable
protective gloves in such cases�
In the event that a battery leaks, remove it
from the product immediately to avoid
damage�
z
Assembly and installation
Please note:
dispose of all packaging
material�
Suitable for hand-held use only� Alternatively,
the cordless work lamp can be attached to a
metal surface by means of the magnet
7
�
Make sure you protect the surface if it is of a
type that marks easily� Make sure that the
surface is flat and level to ensure the light is
firmly attached. Alternatively, the cordless
work lamp can also be attached by means
of the hook
8
�
z
Charging the battery
If the lamp is on, switch it off by pressing
the ON/OFF button
4
�
Place the charging station
9
on a flat,
level surface, making sure to protect the
surface if it is of a type that marks easily�
Place the cordless work lamp
1
in the
charging station supplied
9
� Now connect
the USB charging cable
12
to the micro-
USB port
11
on the charging station
9
and connect the other end of the cable to a
standard SELV USB interface�
The battery will then start charging� The
battery charge level of the cordless work
lamp
1
is indicated by the blue flashing
light of the three-level charge status
indicator
5
�
Level one
= approx� 35 %,
Level two
= approx� 67 %,
Level three
= 100 %
The charging station
9
has a red standby
LED
10
that indicates when it is ready for
use� The standby LED
10
is permanently on
whenever the charging station
9
is
connected to a power source�
The cordless work lamp can also be
charged without the charging station� To do
so, connect the USB charging cable
12
to
the micro-USB port
6
and a standard SELV
USB interface�
z
Switching the cordless
work lamp ON/OFF
Unfold the cordless work lamp�
The ON/OFF button
4
switches the
cordless work lamp on/off and also
controls its brightness� The battery charge
level is indicated by the charge status
indicator
5
� Pressing the ON/OFF button
4
once sets the COB LED to 100%
brightness� Pressing the ON/OFF button
4
again reduces the COB LED brightness
to 50%� Pressing the ON/OFF button
4
a
third time switches the COB LED off and the
LED (front light)
2
on� To switch the LED
(front light) off, press the ON/OFF button
4
once again�
