40
GB/IE/NI/CY/MT
replaced; if it is damaged, the product must
be disposed of.
Fully unwind the cable before using the
product.
You should only connect the product to an
easily accessible power outlet socket so that
you can quickly disconnect it from the
power supply in the event of a fault.
Always unplug the mains power cable
before assembling, dismantling or cleaning
the product.
Always disconnect the product from the
mains power supply if it is not going to be
used for an extended period (e.g. holiday)
or if you want to set it up in a different
place.
Do not immerse the product in water or any
other liquids.
Keep the product away from naked flames
and hot surfaces.
Never tamper with or modify the product.
Do not open up the casing and only have
the product repaired by qualified
professionals. To that end you should
contact a specialist repairer. No liability or
warranty claims are accepted in cases
where repairs have been carried out by
unauthorised persons or the product has
been incorrectly wired or used.
Before using the product, make sure that the
mains power supply voltage matches the
supply voltage required by the product (see
„Technical data“).
AVOID THE RISK OF
FIRE AND INJURY!
RISK OF BURNS FROM HOT
SURFACES!
To avoid the risk of
burns, make sure that the product is
switched off and has cooled down before
you touch it. Light sources generate a large
amount of heat.
Do not cover over the product with other
objects. Excessive heat build-up can cause
a fire.
Do not leave the product unattended while
in use. Excessive heat build-up can cause a
fire.
RISK OF INJURY!
Incorrect
handling of the product may
potentially result in personal injury.
The LED module
6
cannot be dimmed.
Never look directly into the light source
(illuminant, LED, etc.). Never look at the
light source (illuminant, LED, etc.) through
an optical instrument (e.g. magnifying
glass).
Should the protective cover be split or
cracked, it must be replaced.
Never direct the LED light beam at reflective
surfaces or towards people or animals.
Failure to follow the above instructions may
cause people or animals to suffer eye
injuries and/or to lose their sight. Even a
weak LED light beam is capable of causing
eye damage.
RISK OF DAMAGE!
Improper
handling of the product may result
in damage to the product.
The light source may only be replaced by
the manufacturer, service technician or a
similarly qualified person.
Do not use the product if you notice any
damage.
z
Before first-time use
Please note:
Take the product out of its
packaging and remove all packing material.
Check that all package contents are
present.
Check if the product or individual parts are
damaged. Should you detect damage, do
not use the product. Please contact the
retailer via the service address indicated.
Setting up your product
The handle
1
(see Fig. A) is intended for
