34 GB/MT
Introduction / General safety advice for electrical power tools
Introduction
Cordless screwdriver PAS 7.2 A1
Q
Introduction
We congratulate you on the purchase of your new
device. You have chosen a high quality product.
The instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as descri-
bed and for the specified applications. If you pass
the product on to anyone else, please ensure that
you also pass on all the documentation with it.
Q
Intended purpose
This device is intended for driving screws into wood,
plastic and metal. Use the appliance only as described
and only for the purposes indicated. The device is
not intended for commercial use. Any other uses, and
modifications to the appliance, are deemed to be
improper usage and may result in serious physical
injury. The manufacturer accepts no responsibility
for damage(s) resulting from improper usage.
Q
Equipment Components
1
Direction of rotation switch / lock
2
Battery display
3
Charging socket (device)
4
ON / OFF switch
5
LED light
6
Tool holder
7
Battery charger
Q
Included items
1 Cordless screwdriver PAS 7.2 A1
1 Battery charger PAS 7.2 A1-1
1 Carry case
1 Operating instructions
Q
technical Data
PAS 7.2 A1 cordless screwdriver:
Rated voltage:
7.2 V
Rechargeable battery
(integrated): LITHIUM
Rechargeable battery
capacity:
1300 mAh
No-load speed:
n
0
0–230 min
-1
Torque:
max. 6 Nm (soft) –10 Nm
(hard)
Tool holder:
6.35 mm (
1
/
4
“)
PAS 7.2 A1-1 Battery charger:
InPUt:
Rated voltage:
230 V~ 50 Hz
Rated power:
12 W
OUtPUt:
Rated voltage:
10 V
Rated current:
510 mA
Charging time:
approx. 3 hrs.
Protection class:
II /
noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 62.3 dB(A)
Sound power level: 73.3 dB(A)
Uncertainty K:
3 dB
Total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Screwing: Vibration emission value
a
h, D
= 0.253 m / s
2
,
uncertainty K = 1.5 m / s
2
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
