Parkside PBH 1500 A1, Translation Of Original Operation Manual

13

PBH 1500 A1

GB

Appliance-specifi c safety instructions 
for hammer drills

■

 Wear ear protectors.

 Exposure to 

noise can cause hearing loss.

■

Use auxiliary handle(s), if supplied with the 
tool.

 Loss of control can cause personal injury.

■

Hold power tool by insulated gripping surfac-
es, when performing an operation where the 
cutting accessory may contact hidden wiring 
or its own cord. 

Cutting accessory contacting 

a “live” wire may make exposed metal parts of 
the power tool “live” and could give the opera-
tor an electric shock.

■

Wear a dust mask.

WARNING! TOXIC DUST!

►

Working with harmful/toxic dusts results in 
health hazards for the person operating the 
appliance and for other persons in the area.

■

ATTENTION – SERVICE LINES! DANGER! 

Take steps to ensure that you do not hit any 
service lines (electricity, gas, water) when 
working with the electric tool. If necessary, 
check with a service line detector before you 
start to cut or drill into a surface.

Original accessories/additional 
equipment

■

Only use the accessories and additional 
equipment that are specifi ed in the operat-
ing instructions and are compatible with the 
appliance.

Initial operation

Additional handle

NOTE

►

For safety reasons, you should only use this 
appliance with the additional handle   
attached.

♦

Remove the additional handle   by turning it 
clockwise direction.

♦

Turn the additional handle   to the desired 
position.

♦

Fix the additional handle   in the new position 
by turning it anti- clockwise.

Depth stop

♦

Open the wing screw  .

♦

Insert the depth stop   into the additional 
handle  .

♦

Ensure that the toothing on the depth stop   is 
facing upwards.

♦

Pull the depth stop   out far enough for the 
distance between the tip of the drill and the tip 
of the depth stop to correspond with the 
required drilling depth.

♦

Re-tighten the wing screw   afterwards.

Tool/chuck:

♦

Pull the locking sleeve   backwards and insert 
the tool/chuck   in the tool holder  .

♦

Release the locking sleeve  . This locks the 
holder. Check that the tool is properly locked by 
pulling it. The system has radial play because of 
the design.

Removing tool/chuck:

♦

Pull the locking collar   on the tool backwards.

NOTE

Tighten the drill in the wheel-rim chuck   at the 
same time. To do this, apply the chuck key to all 
the 3 positions on the wheel-rim chuck   and 
tighten the tool (e.g. drill) at the same time.

 WARNING!

►

Do not use the wheel-rim chuck   for ham-
mer drilling or chiselling!

IB_108020_PBH1500A1_DE_AT.indb   13

14.01.15   09:01