Parkside PBH 1500 E5, Translation Of The Original Instructions

PBH 1500 E5

■ 

6 

│

GB

│

IE

│

NI

│

CY

Tool/chuck:

♦

Pull the locking collar   backwards and insert 
the tool/wheel-rim chuck   in the tool holder 

 .

♦

Release the locking collar   . This locks the 
holder . Check that the tool is properly locked 
by pulling it . The tool has radial play because 
of its design .

Removing the tool/chuck:

♦

Pull the locking collar   on the tool backwards .

NOTE

Tighten the drill in the wheel-rim chuck   at the 
same time . To do this, apply the chuck key   in 
sequence to all of the 3 positions on the wheel-
rim chuck   and tighten the tool (e .g . drill) at 
the same time .

►

Clamping a tool:    

Turn the chuck key   clockwise .

►

Removing a tool:   

Turn the chuck key   anticlockwise .

WARNING!

►

Do not use the wheel-rim chuck   for hammer 
drilling or chiselling!

Operation

Select operating mode

WARNING!

►

Do not press the function selector switch   
until the appliance has come to a complete 
standstill . Switching between functions while 
the tool is still rotating can damage the 
appliance . 

Function selector switch:

♦

Press and hold the release button   on the 

function selector switch   . Turn the function 
selector switch   so that the required symbol 
engages at the arrow mark:

Function

Symbol

Drilling

Hammer drilling

Chiselling

Chisel position adjust-
ment

Adjusting the chisel position:

You can rotate the tool to the required position for 
chiselling using this function .

♦

Turn the function selector switch   to the   
position .

♦

Turn the tool in the tool holder   to the re-
quired position .

♦

Turn the function selector switch   to the   
position for the chiselling function .

Preselecting the rotation speed

You can use the rotational speed preselector dial   
to preselect the rotational speed . Level 1 (low rota-
tional speed) up to level 6 (high rotational speed) .
Work out the correct settings by carrying out a test .
-   Level 3–6: high speed: for hammer drilling/

chiselling in concrete or stone

-   Level 1–3: low speed: for drilling in steel or 

wood

LED display

■

The green LED 

3a

 lights up when the mains  

plug is inserted .

■

The red LED   lights up when the carbon 
brushes are worn down .    
Stop all work and send the appliance to  
customer service .