GB
│
IE
│
17
■
PBS 900 C3
h)
Keep handles and grasping surfaces dry,
clean and free from oil and grease.
Slippery
handles and grasping surfaces do not allow
for safe handling and control of the tool in unex-
pected situations .
5 . Service
a)
Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts.
This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety instructions
for belt sanders
■
Hold the appliance by the insulated handles
since the grinding belt can come into contact
with its own power cable.
Damage to a live
wire may make exposed metal parts of the power
tool live and could give the operator an electric
shock .
Safety information for sanders
WARNING!
■
Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health .
■
Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity .
■
Wear safety goggles and a protective dust
mask!
Operation
Tensioning/replacing the abrasive
belt
WARNING! RISK OF INJURY
■
Always remove the power plug from the wall
socket before carrying out any work on the
belt sander .
1 . Loosen the clamping device for the abrasive
belt by swivelling the clamping lever all the
way out (see fig . A) . The clamping device is
now open and the abrasive belt can be re-
moved .
2 . Now fit a new abrasive belt or swap the belt
to work a different material or to use a different
grain size .
IMPORTANT:
The direction of the
arrows on the inside of the abrasive belt and
on the appliance housing must match .
3 . Push the clamping lever back into its initial
position .
Adjusting the abrasive belt:
♦
Pick up the appliance, switch it on and turn it
over . Adjust the belt tracking . To do this, turn
the adjustment screw until the edge of the
abrasive belt is flush with and runs parallel to
the appliance edge (fig . B) .
IMPORTANT:
It is important to ensure that the abrasive belt
does not rub against the housing . Check the
belt tracking regularly and adjust it with the
adjusting screw if required .
Summary of Contents for PBS 900 C3
Page 3: ...A B C D ...
Page 49: ... 46 NL BE PBS 900 C3 ...
Page 73: ... 70 CZ PBS 900 C3 ...
Page 85: ... 82 SK PBS 900 C3 ...
