Parkside PBSD 600 A1, Translation Of The Original Instructions

GB

│

IE

│

NI

│

CY

│

 3

■

PBSD 600 A1

NOTE

►

The vibration emission values and the noise 
emission values given in these instructions 
have been measured in accordance with a 
standardised test procedure and can be used 
for comparison of the power tool with 
another tool .

►

The specified total vibration values and the 
noise emission values can also be used to 
make a provisional load estimate . 

WARNING!

►

Depending on the manner in which the 
power tool is being used, and in particular 
the kind of workpiece that is being worked, 
the vibration and noise emission values can 
deviate from the values given in these instruc-
tions during actual use of the power tool .

►

Try to keep the load as low as possible . 
Measures to reduce the vibration load are, 
e .g . wearing gloves and limiting the working 
time . Wherein all states of operation must be 
included (e .g . times when the power tool is 
switched off and times where the power tool 
is switched on but running without load) .

General Power Tool 

Safety Warnings

WARNING!

►

Read all safety warnings, instructions, 
illustrations and specifications provided 
with this power tool.

 Failure to follow all 

instructions listed below may result in electric 
shock, fire and/or serious injury .

Save all warnings and instructions for future 
reference.

The term „power tool“ in the warnings refers to 
your mains-operated (corded) power tool or 
battery-operated (cordless) power tool .

1 .  Work area safety

a)  

Keep work area clean and well lit.

 Cluttered 

or dark areas invite accidents .

b)  

Do not operate power tools in explosive 
atmospheres, such as in the presence of 
flammable liquids, gases or dust.

 Power tools 

create sparks which may ignite the dust or 
fumes .

c)  

Keep children and bystanders away while 
operating a power tool.

 Distractions can cause 

you to lose control .

2 .  Electrical safety

a)  

Power tool plugs must match the outlet. Never 
modify the plug in any way. Do not use any 
adapter plugs with earthed (grounded) 
power tools.

 Unmodified plugs and matching 

outlets will reduce risk of electric shock .

b)  

Avoid body contact with earthed or grounded 
surfaces, such as pipes, radiators, ranges and 
refrigerators.

 There is an increased risk of elec-

tric shock if your body is earthed or grounded .

c)  

Do not expose power tools to rain or wet 
conditions.

 Water entering a power tool will 

increase the risk of electric shock .

d)  

Do not abuse the cord. Never use the cord 
for carrying, pulling or unplugging the power 
tool. Keep cord away from heat, oil, sharp 
edges or moving parts.

 Damaged or entangled 

cords increase the risk of electric shock .

e) 

 When operating a power tool outdoors, use 
an extension cord suitable for outdoor use.

Use of a cord suitable for outdoor use reduces 
the risk of electric shock .

f)  

If operating a power tool in a damp location 
is unavoidable, use a residual current device 
(RCD) protected supply.

 Use of an RCD 

reduces the risk of electric shock .