Parkside PDAP 75 A1, Original Instructions Manual

PDAP 75 A1

■ 

8 

│

GB

│

IE

│

NI

Lubrication

NOTE

►

Regular lubrication is particularly important  
to avoid friction and corrosion damage.  
We recommend using a suitable special oil 
for compressed air appliances (e.g. Liqui 
Moly compressor oil).

–

Lubrication with mist oiler 

A mist oiler (not supplied) continuously 
and optimally lubricates the grinder as  
a preparation stage after the pressure  
reducer. A mist oiler gives off fine drops 
of oil into the air flow and thus guaran-
tees a regular lubrication.

–

Manual lubrication 

If you do not have a mist oiler, lubricate 
the appliance before every use or longer 
work sessions. Add 3–4 drops of pneu-
matic oil into the connector nipple  .

Topping up the oil

To ensure that the compressed air polisher remains 
operational for as long as possible, make sure that 
there is sufficient pneumatic oil in the appliance.

The following options are available:

♦

Attach a maintenance unit with an oiler to the 
compressor.

♦

Install a fitted oiler into the compressed air line 
or the compressor.

♦

Add 3–5 drops of pneumatic oil into the con-
nector nipple   every 15 minutes of operation.

Connecting to a compressed air 
source

NOTE

►

Before connecting the compressed air source,

–

the correct working pressure (3–6 bar) 
must be fully reached

–

make sure that the trigger is in the upper 
position

♦

Attach the appliance to a compressor by con-
necting the connector nipple   with the supply 
hose of the compressed air source.

♦

The compressed air source must be equipped 
with a pressure reducer so that you can regu-
late the air pressure.

Operation

Switching on and off

Switching on:

♦

Press the trigger   to turn the appliance on.

Switching off:

♦

Release the trigger  .

♦

When you have finished working, disconnect 
the appliance from the compressed air source.

Polishing

♦

Add a little polish to the fitted polishing attach-
ment  ,   and the workpiece.

–

Polishing hood   (orange) for pre-polishing

–

Polishing hood   (black) for final polishing

–

Fake fur attachment   for high-gloss polishing

♦

Manually spread the polish of the surface you 
want to polish.

♦

Switch on the compressed air source and allow 
it to run until the maximum tank pressure has 
been reached.