7
GB
Introduction
Introduction / Safety instructions
Sound pressure level:
95 dB(A)
Uncertainty K:
2.5 dB
Values determined in
accordance with:
EN ISO 15744
Weight:
970 g
Wear ear protection!
Vibration emission value = 16.98 m / s
2
uncertainty K = 1.34 m / s
2
Values determined in accordance with
EN ISO 28927-3, EN 12096
The noise levels given in these instructions have
been measured in accordance with a standardised
measurement procedure specified in EN ISO 15744
and can be used to compare appliances. Different
uses of the pressurised air tool give rise to different
noise levels and in some cases they may exceed
the values given in these instructions. It is easy to
underestimate the noise load if the compressed air
tool is used regularly under those circumstances.
Note:
For an accurate assessment of the noise
loads experienced during a particular work period,
you should also take into account the intervening
periods of time when the appliance is switched off
or is running but is not actually in use. This can re-
sult in a much lower noise load over the whole of
the work period.
Safety instructions
Please read all safety in-
formation and instructions.
Failure to comply
with the safety advice and instructions can result in
severe injuries and / or damage to property.
For future reference keep all the safety
advice and instructions in a safe place.
Check the appliance for damage be-
fore bringing it into use.
Do not use the
appliance if you discover any defects.
Keep children and other per-
sons away from the appliance
during use.
Distractions can cause
you to lose control of the appliance.
Do not soak materials or areas that
are to be worked on with liquids con-
taining solvents.
Avoid sanding of paints containing
lead or other material detrimental to
your health.
Do not work on materials containing
asbestos.
Asbestos is considered carcinogenic.
Avoid contact with the running sanding
disc.
Only use the appliance with the
attached sanding disc.
Always keep the device clean, dry
and free of oil or grease.
Keep your workplace clean.
Material
mixtures are particularly dangerous. Aluminium
dust can burn or explode.
Secure the work-piece firmly.
Use clamps
or a vice to firmly hold the work-piece. This
results in a safer grip than with your hand.
Under no circumstances should you
place your hands next to or in front of
the appliance or on the area to be
worked,
you could be seriously injured if the
appliance slips.
Ensure that nobody is endangered by
flying sparks.
Remove combustible materi-
als from the immediate vicinity. Flying sparks
are produced when metals are ground.
Introduce the appliance to the work-
piece when it is switched on.
When the
task is complete, lift the appliance from the
work-piece and then switch it off.
Let the switched off appliance come
to a complete standstill before putting
it down.
After every use check the speed and
the noise level.
Check speed regularly.
ATTENTION!
Clean the appliance before
maintenance from all dangerous substances
96905_par_Druckluft_Exzenterschleifer_content_SI.indd 7
30.04.14 15:46
