42
PDEXS 150 B2
GB
MT
■
If universal rotary joints (claw couplings) are
used, locking pins must be used to provide pro-
tection; Whipchek
®
air hose restraints must be
used to provide protection in case of a failure
of the connection of the hose to the machine.
■
Ensure that the maximum permissible pressure
stated on the machine is not exceeded.
■
Never carry compressed-air-powered machines
by the hose.
Special safety instructions
■
Always wear eye protection when using
or maintaining the sander.
■
Always wear suitable protective clothing.
Protect your hands, hair and clothes from being
drawn in by rotating parts.
■
Always wear a dust mask in situations in
which large amounts of dust are being
generated.
■
Always wear hearing protection.
■
Always wear protective gloves.
■
Only connect the sander to the compressed air
network when it is switched off.
■
Sparks are created during grinding. Ensure that
nobody can be endangered by flying sparks.
You should also remove any flammable materials
or objects.
■
Do not carry the grinder if it has been connected
to the compressed air hose.
■
Be aware of the danger caused by a flailing
compressed air hose!
■
The grinder is not approved for use with cutting discs!
■
The flow pressure of 6.3 bar may not be
exceeded during operation.
■
Never use oxygen or other flammable gases as
an energy source.
■
Switch the appliance on before applying it to the
workpiece. After completing the task, lift the ap-
pliance from the workpiece and then switch it off.
■
Once you have completed your work, switch
the grinder off and place it down securely once
it has come to a standstill.
Caution! Grinder continues to run.
■
Once you have completed your work, disconnect
the grinder from the compressed air supply.
■
Be aware that when processing certain materials
there is a danger that dust and vapours can arise
that could create an explosive atmosphere.
Use vacuum cleaners and suitable protective
equipment.
Before initial operation
NOTE
►
The grinder may only be operated on cleaned,
oil-atomised compressed air and may not
exceed the maximum operating pressure of
6.3 bar at the appliance. The compressor
must be fitted with a pressure reducer to
regulate the working pressure.
►
Wind the Teflon tape supplied around all
threaded connectors.
Fitting the connector nipple
♦
Remove the plastic protective cap from the
appliance’s air inlet.
♦
Wrap the threads on the connector nipple
with the Teflon tape supplied.
♦
Screw the connector nipple into the air inlet.
Fitting the grinding disc
The compressed air-powered random orbital
sander is equipped with a protective cuff .
■
Rotation direction indicator of the
grinding disc .
♦
To fit or replace the grinding disc invert the
protective cuff (see Fig. 1).
Fig. 1
Summary of Contents for PDEXS 150 B2
Page 3: ......
Page 51: ...48 PDEXS 150 B2...
