Parkside PDEXS 150 C2, Operating Instructions Manual

PDEXS 150 C2

■ 

10 

│

US - EN

Maintenance and cleaning

 WARNING! RISK OF INJURY!  

Disconnect the appliance from the 
compressed air supply.

►

Before maintenance, clean off any hazardous 
substances that may (due to working processes) 
have accumulated on the appliance.  
Avoid all skin contact with these substances.  
If the skin comes into contact with hazardous 
dusts, this can lead to severe dermatitis. If dust 
is produced or swirled up during maintenance, 
it can be inhaled.

►

To ensure correct functioning and long-term 
durability of the sander, pay attention to the 
following points:

■

Sufficient and continuously intact oil lubrication 
is highly important for optimum functioning.

■

Check the speed and vibration levels after each 
use.

■

Check the idle speed regularly and after any 
maintenance is performed:  
use a rev counter and perform the measurement 
without any clamped tools. The idle speed may 
not be exceeded under any circumstances at a 
residual pressure of 90 psi (6.3 bar).

■

If the appliance is exhibiting excessive vibration 
levels, the cause of the vibrations must be identi-
fied and repaired.

■

Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you 
could put users at danger. In doubt, contact the 
Service Centre.

■

Check the sanding disc   regularly for damage.

■

Clean the appliance with a soft, dry cloth only.

■

Never use sharp or scratchy cleaning agents 
under any circumstances.

Troubleshooting

Fault

Possible 
cause

Remedy

Speed too 
slow, air 
escapes from 
the outlet.

Motor parts 
jamming due 
to dirt.

Check the 
pressure sup-
ply filter for 
contamination.

Pressure sup-
ply too low.

Check the 
pressure sup-
ply filter for 
contamination.

Lubricate 
appliance as 
described in 
the instruc-
tions.

If necessary, 
repeat the 
steps outlined 
above.

Appli-
ance does 
not move; 
compressed 
air escapes 
completely 
through the 
outlet.

Motor is 
jammed due 
to material 
build-up.

Lubricate 
appliance as 
described in 
the instruc-
tions.