PDFP 500 C3
■
36
│
GB
│
MT
Setting the paint jet pattern
The appliance has two settings: round jet and
broad jet.
Round jet
Broad jet
Setting the round jet
■
Use the round jet for small surfaces, corners
and edges.
♦
Turn the control clockwise
.
Setting the broad jet
■
You can use the broad jet vertically or horizon-
tally for larger surfaces.
♦
Turn the control anticlockwise
.
The nozzle head can be turned into any
position between the horizontal and the vertical.
Adjusting the paint flow
NOTE
►
The front locking bolt is designed to limit
the adjustment range of the stroke limiter
screw .
Increasing the paint flow
♦
Turn the stroke limiter screw anticlockwise.
Decreasing the paint flow
♦
Turn the stroke limiter screw clockwise.
Adjusting the airflow
NOTE
►
We recommend starting with the airflow set
to maximum. To do this, open the airflow
regulator to maximum as described below
in the section "Increasing the airflow".
Increasing the airflow
NOTE
►
Increasing the airflow is generally advisable
if the dispersion is too coarse.
♦
Turn the airflow control anticlockwise.
Decreasing the airflow
NOTE
►
Decreasing the airflow is generally advisable
if the paint mist is too strong.
♦
Turn the airflow control clockwise.
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
NOTE
►
Thorough cleaning after every use is very
important for safety and operation. Other-
wise, the needle could get blocked and
proper operation of the appliance cannot
be guaranteed.
■
Wear suitable gloves when cleaning.
■
Do not use any hydrocarbon-based solvents like
benzene, ethyl chloride, etc., as these could
trigger chemical reactions with some of the
materials in the paint spray gun. This can lead
to dangerous reactions.
CAUTION!
►
Never immerse the paint spray gun com-
pletely in solvent.
Summary of Contents for PDFP 500 C3
Page 3: ...A B C D ...
