■
6
│
GB
│
IE
│
NI
PDFS 1300 A1
n)
Do not leave the power tool running whilst
carrying it.
Accidental contact between your
clothing and the rotating accessory tool could
cause your clothing to get caught and the ac-
cessory tool to penetrate a part of your body .
o)
Clean the ventilation slots of your power tool
regularly
. The engine fan draws dust into the
housing and a strong accumulation of metal
dust can cause electrical hazards .
p)
Do not use the power tool in the vicinity of
flammable materials.
Sparks can ignite such
materials .
q)
It may be necessary to use water or some
other coolant when operating this appliance.
It may therefore only be connected to circuits
protected by residual current circuit breakers.
Check that the residual current circuit breaker
is functioning correctly on a regular basis.
Working with equipment that uses water or
other coolants may result in an electric shock
or fatal electrocution if no residual current
circuit breaker is used.
r)
Keep your hands away from the cutting area
and the cutting disc. Keep your other hand on
the additional handle or the motor housing.
If you hold the machine with both hands, the
cutting disc cannot cause injuries to your hands .
s)
Never reach under the workpiece.
The guard
cannot protect you from the cutting wheel be-
low the workpiece .
t)
Never hold the workpiece you are cutting in
your hands or on your leg. Secure the work-
piece on a stable platform.
It is important to
properly support the workpiece to protect your
body, prevent the cutting disc from jamming and
to maintain control of the tool .
u)
Never use damaged or incorrect washers or
a damaged or incorrect bolt for the cutting
disc.
The washers and bolts for the cutting disc
are specially designed for your machine to
achieve optimum performance and reliability .
v)
Do not unplug the power cord if it or the outlet
has become wet.
First switch off the power by
removing the fuse or via the circuit breaker of
the circuit in question . Afterwards, you can pull
out the plug and check the connections for any
traces of water .
WARNING!
►
To avoid the risk of electric shock, keep all
connections dry and away from the ground .
Do not touch the power plug with wet hands .
►
The cable set is equipped with a portable
residual current device . For additional safety,
sockets with integrated portable residual
current devices are available . When using an
extension cord, always plug it into an outlet
protected by a portable residual current
device .
►
Always plug an extension cord into an outlet
protected by a portable residual current
device .
►
Never use the appliance with salt water or
conductive liquids .
►
Grooves and slots in load-bearing walls are
subject to DIN 1053-1 and/or country-spe-
cific regulations . These regulations must be
observed under all circumstances . Before
starting work, contact the responsible structur-
al engineer, architect or site manager .
►
Approved cutting disc designs:
segmented diamond discs with maximum
slots between the segments of 10 mm, only
with negative cutting angle .
Summary of Contents for PDFS 1300 A1
Page 3: ...A B C ...
Page 4: ...E D F ...
