Parkside PDFS 1300 A1, Original Instructions Manual

■ 

8 

│

GB

│

IE

│

NI

PDFS 1300 A1

j)  

Be particularly careful when making pocket 
cuts into existing walls or other obscured areas.

The inserted cutting disc may cut into gas or 
water pipes, electrical wiring or other objects 
that can cause a kickback .

k)  

Position your body on one of the two sides of 
the cutting disc, but not in line with the cutting 
disc

 .

Supplementary notes

Wear ear muffs!

Wear safety goggles!

Wear safety shoes!

Wear protective gloves!

Wear a dust mask!

Not approved for side grinding

Original accessories/auxiliary equip-

ment

■

Use only the accessories and additional 
equipment that are specified in the operating 
instructions and are compatible with the  
appliance.

Residual risks

Despite compliance with the applicable safety reg-
ulations and the use of protective devices, certain 
risks cannot be avoided . These are the following:

■

Hearing loss

■

Risk of injury due to flying fragments

■

Risk of burns due to accessories becoming hot 
during operation

■

Risk of injury due to prolonged use .

Working procedures

■

Secure the workpiece. 

Use clamps/a vice to 

hold the workpiece firmly in place . This is much 
safer than simply holding it in your hand .

■

Materials containing asbestos may not be 
processed.

 Asbestos is a known carcinogen .

Tip! This symbol indicates proper 
behaviour.

DANGER! ALWAYS GUIDE THE  

APPLIANCE THROUGH THE WORK-

PIECE IN REVERSE ROTATION .

►

In the opposite direction there is a risk of 
kickback . The appliance can be pushed out 
of the cut .

■

Always hold the appliance firmly with two 
hands while working. 

Ensure that your stance  

is secure and stable .

■

When working on angled surfaces, do not 
exert great force on the workpiece. 

If the 

rotational speed drops significantly, you must 
reduce the pressure exerted to allow safe and 
effective working . If the appliance suddenly 
brakes completely or jams, it must be switched 
off immediately .

■

Cutting: Work with a moderate feed and do 
not tilt the cutting disc.

■

Cutting discs become very hot when work-
ing – let them cool down completely before 
touching them.

■

Never use the appliance for purposes other 
than those for which it was designed.

■

Remain alert at all times! Always pay atten-
tion to what you are doing and act with com-
mon sense. 

Do not use the appliance if you are 

distracted or feeling unwell .