11
GB/IE/CY
Operation
Filling the blast medium container
Always use a suitable blast medium for your sand blasting work.
NOTE:
We recommend using a silica-free blast medium
(e.g. ground blast furnace slag) with a grading of 0.2 mm – 0.8 mm.
Ensure that the blast medium is completely dry and not too coarse.
NOTE:
The maximum particle size is 0.8 mm.
Turn the bayonet cap of the blast medium container
4
to open it.
Pull the blast medium container
4
off downwards.
Fill the blast medium container
4
with the desired amount of
blast medium.
Ensure that the maximum capacity of the container (1000 ml) is
not exceeded.
Screw the blast medium container
4
back on and lock it in place
by inserting and turning it on to the container lid (see Figs. A).
Using the sandblasting gun
(see Figs. B, C)
Carefully prepare the workpiece before sand blasting it.
Clean it if necessary.
NOTE:
Deposits of dust and grease can have a considerably
detrimental effect on the result.
Carefully mask or tape off everything that is not to be sand blasted.
Ensure that there is always a minimum distance of 20 cm between
the sandblasting gun
1
and the surface being sand blasted.
Switching on:
Press the trigger
2
to start operating the sandblasting gun
1
.
Summary of Contents for PDSP 1000 A1 SANDBLASTER GUN
