GB/IE/NI
9
Operation
Operation
Setup and use
NOTE: Always operate the product with com-
pressed air that is clean, oil-free and moisture-free.
Do not exceed the maximum working pressure of
8 bar at the device.
NOTE: To be able to control the air pressure,
the compressed air supply must be equipped
with a pressure regulator.
Connect the product to a suitable compressed
air source by plugging the quick-connect plug
on the supply hose to the barbed fitting
4
on
the product. The plug locks into place
automatically.
Using the tyre inflator
with pressure gauge
1. Plug the valve connector
5
into the valve
2. Press the trigger lever
6
to start supplying
compressed air.
3. Release the trigger lever
6
to stop supplying
compressed air. Use the pressure gauge
1
to
check the pressure.
4. If the pressure is too high (too much air) in the
object you are filling: Press the vent valve
3
to
release some air.
5. Press the lever on the valve connector
5
down
and unplug the valve connector
5
from the
valve.
6. Disconnect the device from the compressor
after completing work.
Using the accessories
Press the lever on the valve connector
5
and
plug in accessory parts
10
to
13
or the
attachment
9
into the valve connector
5
.
Using the air blow gun
1. Screw an extension nozzle
8
onto the
pneumatic air blow gun
7
.
2. Press the trigger lever
6
to start supplying
compressed air.
3. Release the trigger lever
6
to stop supplying
compressed air.
4. Disconnect the device from the compressor
after completing work.
NOTE:
Detach the hose from the compressor first,
before you remove the supply hose from the device.
This will prevent a situation where the supply hose
whips around uncontrollably.
Maintenance
DANGER OF INJURY!
Always disconnect the device from the compressed
air supply before cleaning it.
The device does not require special maintenance.
Care and cleaning
Do not use sharp objects to clean the device.
Do not allow liquids to get inside the device –
this can cause damage to the device.
Clean the device regularly. The best time to do
so is straight after completing work.
Clean the device housing with a dry cloth.
292180 Druckluft-Einstiegs-Zubehoer-Set_content_LB6.indb 9
27.11.17 13:50
Summary of Contents for PDSS C3
