www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
12
k
12
SETTING THE PLANING DEPTH
The planing depth can be set between 0 - 3.5 mm. Turn the guide handle/ planing depth adjuster
and set the pointer to the desired mark or value.
DUST REMOVAL AND VACUUM EXTRACTION
The planing debris removal channel
can be configured to the left or right as required by simply
inserting a closing cap and vacuum hose adapter.
OPERATING INSTRUCTIONS
Always switch on the planer before making contact with the material and then guide the planer on to
the workpiece.
PLANING SURFACES
Place the planer with the front of the base plate
on the workpiece.
Always make sure when you are planing surfaces such as beams and boards that the base plate
is
in full contact with the surface to avoid the danger of blade kickback.
Always use both hands to guide the plane over the workpiece with even forward pressure.
CHAMFERING CORNERS
The vee groove
in the centre of the front of the base plate
allows you to chamfer the corners of
your workpiece very quickly and easily. Place the planer on to the workpiece with the vee groove
on the corner and then guide the planer along the corner. Make sure you keep the angle at 45° and
an even forward pressure.
REBATING
Example set up: for right hand rebates the side fence
goes on the left and the rebating depth
stop
goes on the right into the holes on the planer (with the planer viewed from above).
Set the rebating depth up to a max. 24 mm using the rebating depth stop
. Set the side fence
to
give the required width. Adjust the planing depth scale
to the maximum of 3.5 mm. Go over the
workpiece as many times as is required to obtain the desired rebate.
12
t
www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
BA_Ident.-No._PEH950-102003-1 21.01.2004 13:33 Uhr Seite 12
Summary of Contents for PEH 950
