Parkside PFE 50 A1, Translation Of The Original Instructions

PFE 50 A1

■ 

6 

│

GB

│

IE

Preparation for work

Prepare the surface to be painted

The surface to be painted must be clean, dry 
and free of grease. When working indoors, any 
surfaces that have not been covered could get 
soiled. Therefore, prepare the surrounding areas 
thoroughly:
-  Cover or tape over floors, furniture, doors and 

window frames.

-  Place sufficient covering material (plastic sheeting, 

cardboard) under the paint bucket and base unit.

Prepare the paint

-  Prepare the paint according to the manufacturer's 

instructions.

- Stir the paint thoroughly and dilute it if necessary.

Prepare paint roller

♦

Before first use, dampen the paint roller evenly 
with clear water and wring out the excess.

Preparable coating materials

Water-based dispersion and latex paints for interior 
and exterior walls.

Non-workable coating materials

Solvent-based paints and coatings and materials 
containing heavily abrasive components.

Assembly

♦

Press the side locks on the handle   downwards. 
Fit the roller bracket  , paying attention to the 
guide slots (see fig. A).

♦

Release the locks again to fix the roller bracket   
in place.

♦

Screw the extension adapter   into the handle   
from below (see fig. B).

♦

To ensure an easy assembling, apply a thin coat 
of lubricating grease   at the marked points. 
(see fig. K + L).

NOTE

►

You can also attach standard extensions for 
paint rollers to the handle   (can be bought 
separately in DIY stores). Push the extension 
into the extension adapter   mounted for 
this purpose. Plugging or screw the exten-
sion of this in one of two mounted extension 
adapter  .

Mounting/changing the paint roller

♦

First push the inner roller   to the paint roller 

   (see fold out page).

♦

Insert now the cap   in the paint roller     
(see fold out page).

Controls on the appliance

Main switch  :

♦

Switches the appliance on (“I”) and off (“O”).

On/off switch paint pump  :

♦

Press once and release to switch on the pump 
to supply paint to the paint roller    . 

♦

To switch off the pump, press the button again.

Operation

♦

Hold the height-adjustable paint bucket attach-
ment   to the side and pull upwards (see fig. C).

♦

Place the paint bucket on the section “X” (see 
fig. D) so that the handle of the paint bucket is 
between the two brackets.

NOTE

►

Important: The handle on the paint bucket 
must be between the two brackets. Other-
wise, the bucket could tip and spill paint 
while being carried.

♦

Push the height-adjustable paint bucket attach-
ment   downwards to fix the paint bucket in 
place (see fig. E).

♦

Fix the intake hose   into the bracket and push 
it down to the bottom of the paint bucket (see 
fig. F).

♦

Switch on the appliance using the main switch  .