10 GB/IE/CY
Q
Before use
Q
Inserting / replacing saw blades
j
Wear appropriate protective gloves
when inserting and testing the blade.
j
Before replacing the blade, make sure that the
saw blade mount is free of any cutting residue
(e.g. wood splinters).
j
If necessary clean the saw
blade mount with a narrow
paintbrush or blow it out with compressed air.
1. Release the hexagonal socket head screw
6
using the Allen key
5
.
2. Insert the saw blade between the plunger
9
and the clamping plate
11
.
Make sure that the locating pin
10
engages in
the locating hole of the saw blade.
3. Retighten the hexagonal socket head screw
6
.
Check before you use the saw that the saw
blade is safely and firmly seated.
Q
Setting the blade speed
The desired blade oscillation speed can be prese-
lected by using the setting wheel
1
(MIN. = lowest
oscillation speed, MAX. = highest oscillation speed).
The blade speed can also be selected whilst you
are using the device.
Q
Pendulum-action settings
You can set the pendulum action using the pendulum-
action rotary switch
4
to adjust the effectiveness
of the sawing action of the blade to suit the material
to be cut.
Setting 0 (pendulum action is switched off):
This setting is suitable for sawing thin or hard mate-
rials. This setting can also be used to produce
clean-cut edges.
Setting I:
Suitable for materials of medium strength, e.g.
hardwood, plastic.
Setting II:
Use this setting when you are sawing soft materials
such as lightweight building or insulation materials.
Setting III:
Set the rotary switch in this position if you are cutting
softwood / pruning trees or soft materials.
Q
Preparing for use
The voltage at the mains socket must match that
shown on the rating plate on the device. Devices
marked with 230 V ~ can also be operated at
220 V ~.
Q
Switching on and off
When operating the device you can select between
intermittent or continuous operation mode.
To switch on intermittent operation mode:
j
Press the On / Off switch
3
.
To switch off intermittent operation mode:
j
Release the On / Off switch
3
.
To switch on continuous operation mode:
j
Press the On / Off switch
3
and fix it in the
pressed position with the lock button
2
.
To switch off continuous operation mode:
j
Press the On / Off switch
3
and release it again.
Before use / Preparing for use
