PFS 710 D3
■
36
│
GB
│
MT
Adjusting the footplate
RISK OF INJURY!
►
Always remove the plug from the power
socket before working on the appliance .
♦
Adjust the footplate according to the cutting
depth .
♦
To do so, undo the locking lever and move
the footplate to the corresponding position .
♦
Lock this position by closing the locking lever .
Stroke rate selection
Use the adjusting wheel to select the desired
stroke rate (– = lower stroke rate, + = increased
stroke rate) .
The stroke rate can also be changed during opera-
tion .
Use
Switching on and off
During operation, you can choose between instan-
taneous and continuous operation .
Switching to instantaneous operation:
♦
Press the ON/OFF switch . The work light
lights up when the ON/OFF switch is
pushed in slightly or fully and illuminates the
working area in low light conditions .
Switching off instantaneous operation:
♦
Release the ON/OFF switch .
Switching to continuous operation:
♦
Press the ON/OFF switch and lock it in this
position with the locking switch .
Switching off continuous operation:
♦
Press the ON/OFF switch and release it
again .
Guiding the sabre blade safely
To adapt to the workpiece and for safe placement,
the footplate can be swivelled . It must always
be in contact with the workpiece when the appli-
ance is running .
Practical advice on sawing
♦
Check the material to be worked to make sure
that all foreign objects have been removed, e .g .
nails, screws, etc . .
♦
Ensure that the ventilation slits are not covered .
♦
Switch the appliance on before moving it
towards the material to be worked .
♦
Switch the appliance off immediately if the saw
blade jams .
Open up the sawn gap using a suitable tool
and pull out the sabre saw .
■
Use the appropriate saw blade and stroke rate
for the material to be worked .
■
Saw blades optimised for your sabre saw are
available from retail stores in different lengths
for various purposes .
■
Saw the material at a constant speed .
Sawing flush to edges:
Using flexible saw blades with a suitable corre-
sponding length, you can saw off protruding work-
pieces such as pipes flush to the wall .
Proceed as follows:
1 . Place the saw blade directly against the wall .
2 . Bend it by applying lateral pressure to the sabre
saw so that the footplate makes contact with
the wall .
3 . Switch the appliance on as described and saw
off the work piece by applying constant pres-
sure .
Summary of Contents for PFS 710 D3
Page 3: ......
