18 GB
Troubleshooting
Problem
Possible cause
Solution
The motor is running but the
spray unit is blocked.
Dried paint residues block the
openings in the area around the
needle
[
2]
.
Pierce the openings in the
area around the needle
[
2]
with the cleaning needle
[
]
.
The product does not spray
although there is still some paint
in the paint container
[
9]
.
The angled riser tube
[
]
in the
paint container
[
9]
points in the
wrong direction.
Reorient the riser tube
[
]
(see “Filling with spray
material”).
Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack
[
]
and let the
product cool down before making any
adjustments!
Cleaning
NOTE
u
Clean the product after each use,
otherwise the nozzles
[
1]
may clog up.
u
Do not use chemical, alkaline, abrasive
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces.
u
Do not use silicone-based lubricants.
u
Never place the entire product in solvent.
u
Wear suitable gloves when cleaning.
Never allow fluids to get into the product.
Regular and proper cleaning will help
ensure safe use and prolong the life of the
product.
Clean the motor unit
[
]
with a dry cloth.
Use a soft brush for areas that are hard to
reach.
In particular clean the air vents after every
use with a cloth and soft brush.
The vents must always be clear.
Spray water with the product after each use.
Clean the following parts with the cleaning
brush
[
]
or the cleaning needle
[
]
:
–
[
1]
Nozzles
–
[
2]
Needle (openings in the area around
the needle)
–
[
4]
Spray unit
–
[
]
Nozzle head
Cleaning the air filter
Fig. F
Remove the air filter
[
]
: Press and hold the
release buttons
[
]
on the air filter cover
[
]
.
Remove the air filter cover.
Remove the air filter
[
]
from the air filter
cover
[
]
.
If necessary, shake out the air filter
[
]
.
In case of more severe dirt accumulation,
clean the air filter
[
]
under running water.
Let the air filter dry thoroughly.
If necessary, replace the air filter
[
]
with the
replacement air filter
[
]
.
Maintenance
The product is maintenance-free.
Before and after each use, check the
product for wear and damage.
Repair
This product does not contain any parts
that can be repaired by the user. Contact
an authorised service centre or a similarly
qualified person to have it checked and
repaired.
Summary of Contents for PFSA 20-Li B2
