15
GB/CY
Operation / Cleaning
Note:
Engraving points are also available from specialist dealers
or DIY shops.
Advice on use
You can use the mini-engraver to produce creative, individual engravings.
For example, you can use it to place identifying marks on your valuables.
You can place numbers and letters on metal, glass, plastic, wood and
ceramic. This is done with the help of the engraving stencil
7
, see Figs.
A and B.
Hold the device at an angle, as you would a pencil.
Your arm should rest on the table.
Using very light pressure, guide the engraving point
5
over the
workpiece. Find the ideal speed of movement by trial and error on
a piece of waste material.
Note:
The engraving point
5
supplied with the product is made
from carbide steel. Therefore it is not suitable for engraving electronic
media such as CDs, DVDs etc. It could damage these materials and
render them illegible.
Cleaning
WARNING!
Before performing any cleaning or maintenance
work, always remove the mains plug from the socket.
Clean all the dirt off the drill / grinder. Use a dry cloth for cleaning.
Summary of Contents for PGG 15 A1
