Parkside PHET 15 A1, Instruction M

27

PHET 15 A1

GB

 WARNING!

►

The vibration level specified in these instructions 
has been measured in accordance with the 
standardised measuring procedure specified 
in EN 60745 and can be used to make 
equipment comparisons. The specified vibration 
emission value can also be used to make 
an initial exposure estimate. The vibration 
level varies in accordance with the use of 
the power tool and may be higher than the 
value specified in these instructions in some 
cases. There is a risk of underestimation of 
the  vibration load if the power tool is used 
regularly in this manner.

NOTE

►

For an accurate estimate of the vibration load 
during a specific working period, the periods 
during which the appliance is switched off or 
is running but not actually being used must 
also be taken into consideration. This can 
significantly reduce the vibration load over 
the total working period.

General Power Tool 

Safety Warnings

 WARNING!

►

Read all safety warnings and all instructions. 
Failure to follow the warnings and instructions 
may result in electric shock, fire and/or serious 
injury.

Save all warnings and instructions for future 
reference.

The term "power tool" in the warnings refers to your 
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1.  Work area safety

a)  

Keep work area clean and well lit.

 Cluttered 

or dark areas invite accidents.

b)  

Do not operate power tools in explosive 
atmospheres, such as in the presence of 
 flammable liquids, gases or dust.

 Power tools 

create sparks which may ignite the dust or fumes.

c)  

Keep children and bystanders away while 
operating a power tool.

 Distractions can cause 

you to lose control.

2.  Electrical safety

a)  

Power tool plugs must match the outlet. Never 
modify the plug in any way. 
Do not use any adapter plugs with earthed 
(grounded) power tools.

 Unmodified plugs 

and matching outlets will reduce risk of electric 
shock.

b)  

Avoid body contact with earthed or grounded 
surfaces, such as pipes, radiators, ranges and 
refrigerators.

 There is an increased risk of electric 

shock if your body is earthed or grounded.

c)  

Do not expose power tools to rain or wet 
conditions.

 Water entering a power tool will 

increase the risk of electric shock.

d)  

Do not abuse the cord. Never use the cord 
for carrying, pulling or unplugging the power 
tool. Keep cord away from heat, oil, sharp 
edges or moving parts.

 Damaged or entangled 

cords increase the risk of electric shock.

e) 

 When operating a power tool outdoors, use 
an extension cord suitable for outdoor use.

Use of a cord suitable for outdoor use reduces 
the risk of electric shock.

f)  

If operating a power tool in a damp location 
is unavoidable, use a residual current device 
(RCD) protected supply.

 Use of an RCD 

reduces the risk of electric shock.