PHKSA 12 A2
■
8
│
GB
│
IE
│
NI
■
Always use the right saw blade for the material
being worked .
■
Use only saw blades with a speed marking
that corresponds to or is higher than the speed
specified for the power tool .
■
Saw blades that are intended for use on wood
or similar materials must comply with EN 847-1 .
■
Do not allow the teeth of the saw blade to
overheat .
■
When sawing plastic, avoid melting the plastic .
■
Wear a dust mask when sawing .
■
Only use recommended saw blades .
■
Always wear hearing protection!
Safety information for circular saw
blades
Wear protective gloves!
Wear a dust mask!
Wear protective goggles!
Wear hearing protection!
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries.
Original accessories/auxiliary
equipment
■
Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.
Before use
Removing/charging/inserting the
battery pack
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger .
NOTE
►
The battery is supplied partially charged .
Before first use, charge the battery in the
charger for at least 1 hour . This guarantees
full battery performance . You can charge the
lithium-ion battery at any time without short-
ening its service life . Interrupting the charging
process does not damage the battery .
►
If the battery overheats during operation, it
cannot be charged immediately . Allow it to
cool down first .
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C .
1 . To remove the battery pack , press the release
button and pull the battery pack out of the
appliance .
2 . Insert the battery pack into the high-speed
charger .
3 . Insert the mains plug into the socket . The control
LED lights up red .
4 . The green charge status indicator LED indicates
that the charging process is complete and the
battery pack is ready .
5 . Insert the battery pack back into the appliance .
Checking blade guard functionality
♦
Pull the release lever for the blade guard as
far as it will go .
The blade guard should move without jamming .
When letting go of the release lever for the blade
guard , it should automatically jump back to its
original position .
Summary of Contents for PHKSA 12 A2
Page 3: ...A B C...
