Parkside PHKSA 12 A2, Translation Of The Original Instructions

PHKSA 12 A2

GB

│

IE

│

NI

│

 9

■

Operation

Fitting/changing the saw blade

Always remove the battery pack before changing 
the saw blade  !
1 .   Set the cutting depth (using the locking screw  ) 

to the minimum position, 0 mm .

2 .   Press the spindle lock button   (until it engag-

es) and hold it in . 

3 .   Undo the tensioning screw   using a hex key   .
4 .   Now, remove the tensioning screw   and the 

clamping flange   (see also fig . A) .

Fig. A: Changing the saw blade

5 .    Pull the blade guard    all the way back using 

the release lever   and keep the blade guard 

 in this position .

6 .   Remove the saw blade   carefully out of the 

appliance from below .

7 .   Fitting a saw blade   is done in the reverse 

order .

8 .   Press the spindle lock button   (until it engages) 

and use the hex key   to tighten the clamping 
screw   .

 WARNING!

►

The arrow on the saw blade   must corre-
spond to the arrow showing the direction of 
rotation 

 (running direction shown on the 

blade guard  ) .

■

Ensure that the saw blade   is suitable for the 
rotational speed of the tool .

Rip fence

♦

Undo the wing screw for the rip fence   and 
place the rip fence   in the rip fence slot   .

♦

Set the desired cut width  
using the scale on the rip fence   and the cut 
out in the base plate   (see also fig . B) . 

The right recess in the base plate is for a cutting 
angle of 0° . 

Fig. B: Cutting width 2 cm

♦

Retighten the wing screw for the rip fence   .

Connecting a dust extraction unit

♦

Attach the adapter for dust extraction   to the 
chip ejector   . 
Optional depending on the diameter of the dust 
and sawdust extraction .

♦

Connect an approved dust and chip extraction 
device .

NOTE

►

When sawing wood or other materials that 
create dusts that are hazardous to health, 
always connect the appliance to a suitable, 
certified suction appliance .

Use

Switching on and off

Switching on:

♦

Push the safety lock-out   to the left or right 
and keep it pressed .

♦

Press the ON/OFF switch   . The LED work 
light   lights up . Once the saw is running, you 
can release the safety lock-out   .

Switching off:

♦

Release the ON/OFF switch   .