Parkside PHLG 2000 C2, Translation Of The Original Instructions

19

PHLG 2000 C2

GB

 General Power Tool  
Safety Warnings  

WARNING!

►

Read all safety warnings and all 
instructions. Failure to follow the 
warnings and instructions may 
result in electric shock, fire and/ 
or serious injury.

Save all warnings and instructions 
for future reference.

The term "power tool" in the warnings  
refers to your mains-operated (corded/ 
mains adapter) power tools or battery-
operated (cordless) power tool.

■

Do not expose power tools to rain 
or wet conditions.

 Water entering 

a power tool will increase the risk  
of electric shock.

■

Do not abuse the cord. Never use 
the cord for carrying, pulling or 
unplugging the power tool. Keep 
cord away from heat, oil, sharp 
edges or moving parts.

 Damaged 

or entangled cords increase the risk 
of electric shock.

■

If operating a power tool in a 
damp location is unavoidable, use 
a residual current device (RCD) 
protected supply.

 Use of an RCD 

reduces the risk of electric shock.

■

Do not use the power tool if the 
switch does not turn it on and off.

Any power tool that cannot be con-
trolled with the switch is dangerous 
and must be repaired.

General instructions for hot air 
blowers

■

This appliance may be used by  
children aged 8 years and above 
and by persons with limited physi-
cal, sensory or mental capabilities 
or lack of experience and know- 
ledge, provided that they are under 
supervision or have been told how 
to use the appliance safely and are 
aware of the potential risks.  
Children must not use the appliance 
as a plaything. Cleaning and user 
maintenance tasks may not be car-
ried out by children unless they are 
supervised.

■

To avoid potential risks, if the appli-
ance power cord is damaged it must 
be replaced by the manufacturer, its 
customer service or by a qualified 
technician.

■

Have your power tool serviced by 
a qualified repair person using  
only original replacement parts.

This will ensure that the safety of  
the power tool is maintained.

■

Plugs and power cords should only 
be replaced by the manufacturer 
of the power tool or the manufac-
turer's authorised customer service 
agent.

 This will ensure that the safety 

of the power tool is maintained.