Parkside PHP 500 D2, Translation Of The Original Instructions

PHP 500 D2

■ 

10 

│

GB

♦

Apply the glue in spots. For flexible materials, 
such as textiles, apply the glue in zigzag lines.

♦

Press the two workpieces to be bonded together 
immediately after applying the glue and hold 
for about 30 seconds. The glued bond is ready 
after about 5 minutes.

♦

During breaks in work, put the glue gun down 
on the plastic stand   or replace it in the 
charger  .

♦

Remove any glue residue after it has cooled 
down with a sharp knife. Bonded joints can be 
released by heating.

Switching the appliance off:

♦

Unplug the appliance from the mains socket.

Changing the nozzles:

The temperature of the nozzle   reach a 
temperature of around 200°C.

■

Wear protective gloves.

♦

Heat the appliance up for about 5 minutes. 
Replace the nozzle   when hot.

■

Risk of burns! Touch the nozzle   only by the 
thermal protection  . The nozzle tip is hot!

NOTE

Hold the appliance vertically with the nozzle 
pointing upwards, otherwise the glue could  
drip out.

Maintenance and cleaning

 WARNING! ALWAYS REMOVE THE 

POWER PLUG FROM THE POWER 
SOCKET BEFORE CLEANING THE 

APPLIANCE.

■

The glue gun is maintenance free.

■

Keep the appliance clean and dry at all times.

■

Never permit liquids to enter inside the appli-
ance. Use a cloth to clean the housing. Never 
use petrol, solvents or cleansers which can 
damage plastic.

Disposal

The packaging is made from environmen-

tally friendly material and can be 
disposed of at your local recycling plant.

Do not dispose of electrical appli-

ances with normal domestic waste!

As required by European Guideline 2012/19/EU, 
worn-out electrical appliances must be collected 
separately and fed into an environmentally compat-
ible recycling process.
Your local community or municipal authorities can 
provide information on how to dispose of the worn-
out appliance.

200