Parkside PHS 160 B3, Operation Manual

13

PHS 160 B3

GB

are about to work on with liquids containing 
solvents.

■

Do not abrade moistened materials or damp 
surfaces.

■

Avoid sanding paints containing lead or other 
substances hazardous to health.

■

Do not work on materials containing asbestos. 
Asbestos is a known carcinogen.

■

Avoid contact with the moving sanding sheet.

■

Operate the device only with an attached sand-
ing sheet.

■

Never use the device for a purpose for which 
it was not intended nor with non-original parts 
/ accessories. The use of tools or accessories 
other than those recommended in the operating 
instructions could lead to you suff ering an injury. 

■

Switch the device off  and allow it to come to a 
standstill before you put it down.

■

Always keep the device clean, dry and free of 
oil or grease.

Preparing for use

 CAUTION!

►

Make sure that the device is switched off  
before you connect it to the mains supply.

NOTE

►

Always switch on the delta sander before 
bringing it into contact with the workpiece 
material.

Switching on the device:

♦

Push the ON / OFF switch   into Position “I“.

Switching off  the device:

♦

Push the ON / OFF switch   into Position “0“.

Vacuum dust extraction

 WARNING! DANGER OF FIRE!

►

There is the danger of fi re when working with 
electrical devices that have a dust box or can 
be connected to a vacuum cleaner. Under 
certain conditions the wood dust in the dust ex-
traction bag (or in the vacuum‘s dust bag) may 
ignite, e.g. as a result of fl ying sparks generated 
when abrading metals or metal objects left in 
wood. This can happen particularly if the wood 
dust is mixed with paint residue or other chemi-
cals and the abraded particles are hot from 
prolonged abrasion. Therefore you must empty 
the device’s dust collection box and the vacuum 
cleaner’s dust bag before taking a break or 
stopping work and always avoid overheating of 
the abraded particles and the device.

Wear a dust mask!

 WARNING!

►

Always pull the mains plug is out of the socket 
before doing any work on the device.

Dust box for internal
vacuum extraction

Mounting:

♦

Slide the dust box for self-generated dust extrac-
tion 

b

 up to the stop on the hand sander.

Removal:

♦

Press the release button   of the dust extrac-
tion box for internal vacuum extraction 

b

 and 

withdraw it towards the rear of the device.

NOTE

►

Empty the dust collector in good time in order 
to ensure the optimum removal of

b

 dust by 

suction.

♦

To do so, remove the dust box 

b

 from the 

device as described above. Open the dust box 
by pulling on the tab 

a

 and remove the cover. 

Now tap both parts to thoroughly clean them.

IB_100087_PHS160B3_LB1.indb   13

28.05.14   13:41