21
GB
z
Maintenance
Before any maintenance:
–
Switch the product off.
–
Remove the battery pack
[
]
.
–
Let the product cool down.
Before every use: Check the product for
defects such as loose, worn or damaged
parts.
Apply oil to the safety knife bar
[
2]
by oil
can or spray (Fig. I and Fig. K).
Check that the screws in the safety knife
bar
[
2]
are tight.
Check covers and safety devices for
damages and correct installation. Replace
as necessary.
Use a knife grinder to sharpen and smooth
out minor nudges on the cutting edge of the
safety knife bar
[
2]
.
Contact a specialist to have a blunt, bent or
damaged safety knife bar
[
2]
replaced.
m
WARNING! RISK OF INJURY!
X
Do not try to install a safety knife bar
[
2]
yourself. Installing a knife safety bar shall
only be done by a specialist.
Any maintenance and repair other than
described in this manual: Contact an
authorised service centre or a similarly
qualified person to check or repair the
product. Only use original parts.
z
Troubleshooting
Problem
Possible cause
Action
Product does not
start.
Battery pack
[
]
is empty.
Charge battery pack
[
]
(see “Charging the battery
pack”).
Battery pack
[
]
is not properly
inserted.
Insert battery pack
[
]
correctly
(see “Removing/inserting the
battery pack”).
Safety switch
[
4]
not pressed
properly.
Switch the product on correctly
(see “Switching the product on/
off”).
Intermittent operation
Internal wiring is defective.
Send the product to Service
Centre for repair.
The on/off switch
[
7]
is
defective.
Safety knife bar
[
2]
gets too hot.
Too much friction due to lack of
lubrication.
Oil the safety knife bar
[
2]
.
The product cuts
poorly.
Too much friction due to lack of
lubrication.
Oil the safety knife bar
[
2]
.
The safety knife bar
[
2]
is dirty.
Clean the safety knife bar
[
2]
.
Suboptimal cutting technique.
Adjust cutting technique
(see “Working instructions”).
Summary of Contents for PHSA 20-Li B2
