15
GB
Setting 5 = 500 °C maximum soldering temperature, e.g. for desolder-
ing large soldered joints
Switching off:
Note:
After use always replace the soldering pencil
1
into the holder.
Press the ON / OFF switch
2
into setting “
0
”.
If the device is not being used, pull the mains lead out of the mains
socket.
Q
Solder sponge
CAUTION!
The hot soldering tip
7
must never be placed in
contact with a dry solder sponge
5
, otherwise the solder sponge
may be damaged.
The solder sponge
5
is used to clean soldering tips.
Moisten the solder sponge
5
before you use it.
Q
Soldering
— The soldering pencil has a rated output of 48 watts and is therefore
ideal for electronics soldering (see Figs. A, B).
— The design of the soldering pencil makes it especially suitable for
use where access is difficult or for fine soldering work.
Clean the soldering tip
7
on the moist solder sponge
5
.
After cleaning the tip
7
it must be “tinned” (coated with solder).
This is done by melting solder on to the hot soldering tip
7
.
Guide the soldering tip
7
to the intended joint site and heat the joint.
Place the solder (with flux) between the joint site and the tip
7
to melt it.
Using the product
Using the product
66449_par_Loetstation_PLS48B1_content_LB4.indd 15
05.08.11 14:23
Summary of Contents for PLS 48 B1
