![background image](http://html2.mh-extra.com/html/parkside/pls-48-d2/pls-48-d2_instructions-for-use-manual_3845058028.webp)
28
PLS 48 D2
|
GB
soldering work.
Clean the soldering tip
on a moist solder sponge
.
After cleaning, the soldering tip must be tinned. Tin the hot soldering tip
by melting the solder
.
Bring the soldering tip to the soldering point and heat it.
Bring the solder (with flux) between the soldering point and the soldering
tip.
Apply additional solder until the entire solder joint is covered.
Immediately remove the soldering tip to avoid overheating the molten
solder.
Let the solder solidify and avoid vibrations.
NOTE
f
The flux is either contained in the solder or it is applied separately.
When purchasing, please find out about the type of application
and the appropriate solder
Cleaning and maintenance
WARNING! RISK OF INJURY! Always
unplug the device from the mains
socket and allow it to cool down before
performing any work on the device .
Clean the device after completing the work.
Use a cloth and a mild detergent if required to clean the housing.
Never use sharp objects, petrol, solvents or cleaners that can damage
plastic.
Summary of Contents for PLS 48 D2
Page 3: ......