10 GB/IE
ATTENTIoN!
Repeat the settings on the op-
posite side.
Never press the spindle lock key
1
when the
grinding disk
4 a
,
4 b
is still rotating.
Switch the device on by pressing the ON / OFF
switch
10
.
Set the appropriate rotational speed using the
rotational speed control
11
.
Switch off the device by pressing the ON / OFF
switch
10
.
Attach the polishing mandrel
RISK oF INjURy!
Remove
the mains plug from the mains socket before you
carry out any work on the appliance.
ATTENTIoN!
Never press the spindle lock key
1
when the
grinding disk
4 a
,
4 b
is still rotating.
Pull out the cap
5
.
Press the spindle lock key
1
to block the shaft.
Screw the polishing mandrel
12
(s. fig. B).
Screw the desired polishing tool
4 c
,
4 d
,
4 e
,
4 f
or
4 g
onto the polishing mandrel
12
(s. fig. B).
Cover the grinding disk
4 a
,
4 b
completely using
the protective hood
2
(s. fig. B).
Reverse the order to disassemble the polishing
mandrel
12
after operation.
Changing the grinding disk
RISK oF INjURy!
Remove the
mains plug from the mains socket before you carry
out any work on the appliance.
The grinding disk
4 a
,
4 b
being
used may not exceed the stated diameter.
Unscrew the fastening screws
17
on the side of
the cover and remove the cover (s. fig. C).
Never press the spindle lock key
1
when the
grinding disk
4 a
,
4 b
is still rotating.
Press the spindle lock key
1
to block the shaft.
Unscrew the union nut
16
from the device.
Remove the safety washer
15
, union nut
16
,
grinding disk
4 a
,
4 b
and centring flange
14
(s. fig. C).
Place the new grinding disk onto the centring
flange
14
and push them onto the shaft
13
(s. fig. C).
Thread the safety washer
15
and the union nut
16
onto the shaft
13
.
Keep the spindle lock key
1
pressed and tighten
the union nut
16
.
RISK oF INjURy!
Never use
the grinding disk
4 a
,
4 b
without the protective
cover.
Re-attach the lateral panel and fasten by tighten-
ing the retaining screws
17
firmly.
Maintenance and Cleaning
RISK oF INjURy!
Remove
the mains plug from the mains socket before you
carry out any work on the appliance.
The device requires no maintenance.
Clean the device immediately after finishing
your work.
Remove and empty the swarf compartment
9
to the side of the device (s. fig. D).
Use a dry cloth to clean the device. Never use
petrol, solvent or cleaners which attack plastic.
Always keep the vents clear.
Remove dust clinging to the device with a brush.
Service centre
have your device
repaired only by qualified specialist
personnel using original manufacturer
parts only.
This will ensure that your device
remains safe to use.
If the plug or mains
lead needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre.
This
will ensure that your device remains safe to use.
Start-up / Maintenance and Cleaning / Service centre
Service centre / Warranty / Disposal
