14
Warranty provided by Walter
Werkzeuge Salzburg GmbH
Dear customer,
This device comes with a 3 year warranty
from the date of purchase. In case of defects
in the product you may be entitled to legal
claims against the seller of the product. These
legal claims are not restricted by the following
warranty.
Conditions of warranty
The warranty period begins with the date of
purchase. Please preserve the original sales
receipt. This document is required as proof of
purchase. If a material or fabrication defect
occur in this prodict within three years from the
date of purchase, the product shall be repaired
or replaced free of cost at our discretion. Within
the three year period the warranty requires the
defective product and the purchase document
(sales receipt) to be provided with a brief written
description of where the defect lies and when it
occurred.
If the defect is covered by our warranty, the
repaired product or a new product shall be
returned to you. A new warranty period does not
begin with the repair or exchange of the product.
Warranty period and legal claims based
on defects
The warranty period is not extended by the
warranty. This also applies to replaced and
repaired parts. Any damages and defects that
may exist at the time of purchase must be notified
immediately after removal from packaging. Any
repairs arising after the expiry of the warranty
period are chargeable.
Scope of the warranty
The device has been manufactured according
to strict quality guidelines and tested diligently
before delivery. The warranty applies to material
or fabrication defects. This warranty does not
cover product parts that are subject to normal
wear and tear and therefore can be considered
as parts subject to wear and tear or for the
damage to fragile parts, e.g switch, batteries or
those made of glass.
This warranty is void if the product is damaged,
not used or maintained properly. All the
11. Warranty
instructions provided in the operating manual
must be followed exactly for proper use of the
product. The purpose of use and actions which
are advised or warned against must necessarily
be avoided.
The product is intended solely for private use and
not for professional use. The warranty is void in
case of misuse or improper handling, use of force
and changes that have not been carried out by
our authorised service centre.
Processing a warranty case
To ensure quick processing of your issue, please
follow the below instructions:
• Please be ready with the sales receipt and the
product number (e.g. IAN 12345) as proof or
purchase for all queries.
• You can refer the product number from the type
label, an engraving, on the cover sheet of your
operating instructions (below left) or as sticker
on the back or lower side.
• If functional or other defects occur, first call or
email the following service department.
• You can then send a product recorded as
defective postage free along with the sales
receipt and information about where the defect
lies and when it has occurred, to the service
centre address provided to you.
This and many other manuals, product videos and
software can be downloaded at
www.lidl-service.com
12. Service
Walter Werkzeuge Service Center
E-Mail: service@walteronline.com
Tel.: 00800 925 837 88
IAN 321840
Supplier:
Please note that the following address is not a
service centre address. Please contact the above-
mentioned service centre first.
Walter Werkzeuge Salzburg GmbH
Gewerbeparkstr. 9
5081 Anif
Austria
NI
