G B
I E
N I
1 6
Cleaning and
maintenance
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.
Cleaning
Do not use cleaning agents or sol-
vents. Chemical substances may at-
tack plastic parts of the equipment.
Never clean the equipment under
running water.
• Clean the equipment thoroughly after
each use.
• Clean the surface of the equipment
with a brush or cloth.
General maintenance
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
.
place damaged parts.
Storage
• Empty the water tank (
13) before
storage: Pull the rubber closure (
11) from the drain opening of the wa-
ter tank and allow the water to drain
off
• Store the appliance in a dry place well
out of reach of children.
• Grinding discs must be stored dry and
upright and are not to be stacked.
Waste disposal and
environmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
them.
domestic waste.
Recycle the corrugated
cardboard outer packaging in an
environmentally friendly manner.
• Hand over the device at an utilization
.
employed can be separated out into
pure materials and recycling can be
implemented. Ask your Service Center
about this.
• Defective units returned to us will be
disposed of for free.
Summary of Contents for PNTS 250 B1
