PPHA 20-Li B2
GB
│
IE
│
3
■
Technical details
Cordless Planer 20V PPHA20-Li B2
Rated voltage
20 V
(DC)
Rated idle speed
n
0
= 14000 rpm
Plane width
82 mm
Cut depth
0–2 mm
Fold depth
max. 17 mm
Maximum high-frequency
output 10 dBm
Battery PAP 20 B3*
Type LITHIUM
ION
Rated voltage
20 V
(DC)
Capacity 4.0
Ah
Cells 10
High-speed battery charger PLG 20 C3*
INPUT
Rated voltage
230–240 V ∼ 50 Hz (AC)
Rated power
consumption 120
W
Fuse (internal)
3.15 A
T3.15A
OUTPUT
Rated voltage
21.5 V
(DC)
Rated current
4.5 A
Charging time
approx. 120 min.
Protection class
II / (double insulation)
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise and vibration data
Noise measurement value determined in
accordance with EN 62841. The A-rated
noise level of the power tool is typically:
Noise emission value
Sound pressure level
L
PA
= 88.3 dB (A)
Sound power level
L
WA
= 99.3 dB (A)
Uncertainty K
=
3
dB
Wear ear muffs!
Total vibration value
Handle a
h
= 3.944 m/s
2
Additional handle
a
h
= 5.950 m/s
2
Uncertainty K
=
1.5
m/s
2
NOTE
►
For an accurate estimate of the vibration load
during a specific working period, the periods
during which the appliance is switched off or
is running but not actually being used must
also be taken into consideration. This can
significantly reduce the vibration load over
the total working period.
►
The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with another
tool.
►
The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
►
Depending on the manner in which the power
tool is being used and, in particular, the kind
of workpiece being worked, the vibration and
noise emission values can deviate from the
values given in these instructions during actual
use of the power tool. Try to keep the vibra-
tion loads as low as possible. Measures to
reduce the vibration load are, e.g. wearing
gloves and limiting the working time. Wherein
all states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
Summary of Contents for PPHA 20-Li B2
