16 GB/IE/NI
–
Protective footwear
–
Protective clothing
Mounting the product
m
WARNING! Risk of injury!
Wear safety gloves!
Wear ear protection!
Wear eye protection!
Wear protective, slip-resistant
footwear!
m
WARNING! Risk of injury!
u
Remove the battery
[
]
from the product
before assembly. Insert the battery
only once the product is completely
assembled.
1.
Mounting the distance roller
(Fig. B):
Push the distance roller
[
]
through the holes on the motor head
[
]
as
far as possible. The distance roller points
upwards.
2.
Mounting the protective cover
(Fig. C):
Place the protective cover
[
]
on
the motor head.
3. Tighten the protective cover with 4 Phillips
screws
[
]
.
4.
Mounting the additional handle
(Fig. E):
Unscrew and remove the pre-
assembled handle screw
[
]
of the auxiliary
handle
[
5]
.
5. Slide the auxiliary handle
[
5]
over the
handle holder
[
]
. The receptor for the
spare spool
[
4]
points upwards.
6. Insert the handle screw
[
]
through the
through hole on the handle holder.
7. Screw on the auxiliary handle with the
handle screw (Fig. E).
Inserting/removing the
battery
o
Removing the battery:
Press the
release button
[
]
and pull out the
battery
[
]
.
o
Inserting the battery:
Place the
battery on the guide track and push it into
the product. The battery audibly snaps in.
Charging the battery
NOTE
Allow a hot battery
[
]
to cool down
before charging.
Only charge the battery if the red LED on
the charge status indicator
[
]
lights up.
1. Remove the battery from the product if
required.
2. Insert the battery in the charging
compartment of the battery charger
[
]
.
3. Connect the charger to a mains outlet.
4. Once the battery is fully recharged, unplug
the charger from the mains outlet.
5. Remove the battery from the charger.
Summary of Contents for PRTA 20-Li D3
Page 3: ...1 4 6 7 8 9 5 2 3 A B C...
Page 4: ...D E 4 5 F1 5...
Page 5: ...20V max 18V...
Page 6: ...G H F5 F2 8 9 F4 7 6 0 180 F3 9 15 1 75 5 2 3 4...
