11
GB
Accessories
The following tools are needed for the safe and
proper use of the block and tackle function:
¾
2 spanners (8 mm)
¾
2 spanners (13 mm)
m
WARNING
u
Do not use any accessories not
recommended by Parkside .
¾
Fasten the hook 12 to the intended mounting
opening 18 . The steel cable 14 now forms a
loop (Fig . C) .
¾
Dismantle the pulley 11 of the extra hook:
Remove the 3 screws (Fig . F) .
¾
Hang the pulley 11 in the loop formed by
the steel cable 14 (Fig . G) .
¾
Attach the screws and the extra hook 10 to
the pulley 11 . Fasten the 3 screws (Fig . H) .
¾
The block and tackle is now operational
(Fig . I) .
Cleaning and care
m
WARNING!
Disconnect the device from the power supply
before inspections, maintenance or cleaning!
Cleaning
¾
Ensure that no water enters the product
interior .
¾
Regular, proper cleaning helps ensure safe
operation and lengthens the service life of
your product .
¾
Clean the product with a dry cloth . Use a
soft brush for hard-to-reach areas .
NOTE
u
Do not use any chemical, alkaline,
abrasive or otherwise aggressive cleaning
or disinfecting agents to clean the product
as they may damage its surfaces .
Maintenance
Test interval
Procedure
Before each use
Check whether the emergency
off switch 7 and control
switch 8 are properly
functioning .
Every 30 cycles* Check the entire steel cable
14 for damages (Fig . K) .
Replace the steel cable
if damaged (available at
specialist retailers) .
Every 100 cycles* Check to ensure the
maximum/minimum length
levers 15 16 are fully
functional without load .
Every 200 cycles* Lubricate the steel cable 14
and the pulley 11 .
Every 800 cycles* Make sure all screws are
securely fastened .
Check the entire product for
signs of wear .
* One cycle corresponds to one upward and
downward movement of a load .
Repairs
There are no parts in the product interior that
can be repaired by the user . Contact a qualified
professional to have the product checked and
repaired .
Summary of Contents for PSZ 250 A1
