GB
│
IE
│
15
■
PTSG 140 A1
■
Check that all moving parts work properly with-
out jamming and whether parts are damaged.
All parts must be properly fitted and meet all
the conditions to ensure the proper operation of
the power tool. Damaged safety devices and
parts must be properly repaired or replaced by
a specialist workshop unless otherwise indicat-
ed in the instructions.
■
Damaged switches must be replaced at an
authorised customer service centre.
■
Do not use any power tools that you cannot
switch on and off with the power switch.
CAUTION!
The use of other tools and accesso-
ries could lead to an increased risk of personal
injury for you.
■
Have your power tool repaired by a qualified
electrician!
This power tool complies with all
relevant safety regulations. Repairs may only
be performed by a qualified electrician using
original spare parts. Failure to do so could put
the user at risk of accidents.
Residual risks
Even if you operate this power tool properly, there
will still be residual risks. The following risks can
occur in relation to the power tool’s design and
structure:
▯
Lung damage, if no suitable breathing protec-
tion is worn.
▯
Hearing damage, if no suitable hearing protec-
tion is worn.
▯
Damage to health caused by vibrations if the
appliance is used for extended periods or is
not properly used and maintained.
WARNING!
■
The power tool creates an electromagnetic
field during operation. This field can, in cer-
tain circumstances, impair active or passive
medical implants. To reduce the risk of fatal
injuries, we recommend that people with
medical implants consult their doctor and the
manufacturer of the medical implant before
operating this machine.
Before use
CAUTION!
■
This appliance is not designed for continuous
operation.
–
If the appliance overheats, switch it off and
allow it to cool down.
Appliance position
■
The appliance can be set horizontally or verti-
cally.
♦
Fix the supplied screw clamp using the screw
clamp mounting to a table edge to prevent
the appliance tipping over.
Assembling/disassembling the
sanding table with sanding table
holder
♦
Undo and remove the hex socket screw and
the plain washer underneath the sanding
table holder .
♦
Now pull the sanding table holder together
with the sanding table off towards the front.
♦
To refit the sanding table , push the sanding
table holder with the sanding table back
into the normal position.
♦
After this, reinsert the hex socket screw and
the plain washer and tighten the screw.
Summary of Contents for PTSG 140 A1
