■
16
│
GB
│
IE
PTSG 140 A1
Replacing or attaching the sanding
paper
CAUTION!
►
Ensure that the appliance has been discon-
nected from the power in order to prevent it
from being accidentally switched on during
the replacement process and causing injuries.
♦
Before replacement, dismantle the sanding table
holder with the sanding table in order to
access the disc more easily.
♦
Select the sanding paper you require and
remove the backing film.
♦
Stick the sanding paper to the sanding
disc making sure not to trap any air
underneath.
NOTE
►
Stick sanding paper you have already
used to one of the storage covers supplied
so that you can reuse it.
Adjusting the sanding table angle
♦
Undo the rotary knobs fixed to both sides of
the sanding table holder .
♦
Using the angle scale you can adjust the
sanding table to the required angle.
♦
The angle can be adjusted to anything from
-10 to +50 degrees.
♦
Next, tighten the rotary knobs so that the
sanding table remains in the required posi-
tion.
Adjusting the angle stop
♦
Undo the angle stop bolt and use the scale
to adjust it to the required angle. The marking
on the scale must match the marking on the
guide rail .
♦
Retighten the stop bolt to retain the angle.
♦
Push the guide rail into the table groove
located on the sanding table .
Dust extraction
WARNING! RISK OF FIRE!
■
When working with electrical appliances that
can be connected to a vacuum cleaner via
a vacuum cleaner adapter, there is a risk of
fire! Under certain conditions, wood dust in
the bag of the vacuum cleaner can sponta-
neously ignite. This can occur due to flying
sparks or when sanding over residual metals
in wood. This is particularly likely if the wood
dust is mixed with paint residues or other
chemicals and the workpiece has become hot
after being used for a long time. Therefore,
do not allow the material being sanded and
the appliance to overheat. Always empty the
vacuum cleaner dust bag before taking work
breaks.
Connecting/removing the dust
extraction unit
Connecting:
♦
Insert the adapter for outside dust extraction
into the extraction nozzle .
When doing so, note the guidance aid on the
appliance and on the adapter .
♦
To lock, turn the adapter clockwise.
♦
If necessary, use the reducer piece by
pushing it onto the adapter .
♦
Push the hose from a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the adapter for external vacuum
extraction or the reducer piece .
Removal:
♦
Pull the vacuum cleaner hose off the adapter
for external vacuum extraction.
♦
To unlock, turn the adapter anticlockwise
until the arrow ( ) points to the slot on the
extraction nozzle .
♦
Pull the adapter for external vacuum ex-
traction including the reducer piece if nec-
essary
off.
Summary of Contents for PTSG 140 A1
