GB
IE
NI
CY
8
area is wet. Only work when the
light conditions are good. There
is a risk of accidents.
• Keep the brush away from all
body parts and in particular
hands and feet when starting
the motor or when the motor is
running.
• Never start the equipment when
it is turned over or not in the
correct working position.
• Switch off the motor and discon-
nect the plug from the mains
socket:
- Whenever you are not using
the equipment
- If the equipment is left unat-
tended
- When the equipment is being
cleaned, maintained or is to
be inspected
- When relocating the equipment
- If the power or extension cable
is damaged
- When you remove or ex-
change the cutting device or
manually adjust the length of
the cutting line
• Never try to stop the brush with
your hands. Always wait until
the brush stops rotating.
• Do not use the device for re-
moving weed or moss not grow-
ing on the ground, i.e. moss
growing on walls or rocks etc.
• Always inspect the brush before
starting the device. Never use
damaged brushes. Replace any
damaged or worn brush.
• The brush must not be mounted
on devices with an engine speed
exceeding the admissible maxi-
mum engine speed of the brush.
• Do not traverse gravel paths
while the equipment is operat-
ing. Gravel can be thrown up
and result in injury.
• Do not operate the equipment
in the vicinity of infl ammable
liquids or gases as this could
give rise to the danger of a fi re
or explosion.
• Store the equipment in a dry
place that is not accessible to
children.
CAUTION! The following
states how damage to the
equipment and possible inju-
ry to people can be avoided:
Taking care of the equipment:
• Ensure that the ventilation open-
ings are not clogged.
• Only use spare parts and ac-
cessories that have been sup-
plied or recommended by the
manufacturer.
• Never try to repair the equip-
ment yourself. All work that has
not been listed in these Instruc-
tions must only be carried out by
an authorised servicing agency.
• Treat the equipment with the
greatest care. Always keep the
equipment clean for better and
safer work. Follow the mainte-
nance instructions.
• Never overload the equipment.
Always work within the stated
capacity range. Do not use low-
power machines for heavy-duty
work. Do not operate the equip-
ment for purposes for which it is
not intended.
• Always inspect the equipment
before it is to be used. Do not
operate the equipment if safety
devices, parts of the cutting de-
Summary of Contents for PUB 500 B1
