Parkside PUG 1600 A1, Operating And Safety Instructions Manual

4

GB/CY

If your machine has different hole spacing for mounting, use the 
crossbars (C) provided as an adapter. (fig. 9-11)
• Connect the crossbars (C) with the support arms (B) and 

secure them with 4 hexagonal screws (E), 4 washers (G), 4 
spring washers (H) and 4 hexagonal nuts (I).

• Place your tabletop machine on the crossbars (C).
• Fasten the tabletop machine with 4 hexagonal screws (F), 4 

washers (G), 4 spring washers (H) and 4 hexagonal nuts (I) 
on each of the crossbars (C).

• Tighten the screws after assembly.
• Fasten the support arms with the mounted tabletop machine 

on the universal tool stand, as described in point 8.2.

8.5 Using the workpiece stops (fig. 12)

The workpiece supports (D) have integrated workpiece stops 
(D.2), which can be used to saw multiple pieces of wood to 
the same length. 
• Loosen the star-grip screw (K) on the desired side of the uni-

versal tool stand and adjust the height of the workpiece sup-
port (D) such that the support surface (D.2) is at the same 
height as the workpiece support of the saw.

• Loosen the star-grip screw (J) to slide the workpiece support 

horizontally. 

• Set the desired distance between the saw blade and the stop 

surface (D.1).

• Lock your setting by tightening the star-grip screws (J) again.

9.  Cleaning, maintenance and storage

m

Important!

Before any cleaning or maintenance work, the electrical tool 
fitted must be switched off and the mains plug pulled out! Risk 
of injury!

9.1 Cleaning

• Keep the universal tool stand as free of dust and dirt as pos-

sible. Rub the universal tool stand clean with a clean cloth or 
blow it off with compressed air at low pressure.

• We recommend that you clean the universal tool stand im-

mediately after every use.

• Clean the device at regular intervals using a damp cloth 

and a little soft soap. Do not use any cleaning products or 
solvents - they could attack the plastic parts of the universal 
tool stand. 

9.2 Storage

m

 Attention!

Store the universal tool stand only in dry locations that are inac-
cessible for unauthorised persons.

10. Disposal and recycling

The equipment is supplied in packaging to prevent it from be-
ing damaged in transit. The raw materials in this packaging 
can be reused or recycled. The equipment and its accesso-
ries are made of various types of material, such as metal and 
plastic. Defective components must be disposed of as special 
waste. Ask your dealer or your local council.

The packaging is wholly composed of 

environment ally-friendly materials that can be 

disposed of at a local recycling centre.

Contact your local refuse disposal authority for 

more details of how to dispose of your worn out 

electrical devices.

11. Transport

m

 Attention!

Do not transport whilst the electric power tool is running.
Before transporting the universal tool stand, pull out the mains 
plug of the electric power tool mounted on it! Risk of injury 
due to electric shock and unexpected start-up of the electric 
power tool!
Two people can lift the universal tool stand by its frame bed 
in order to move the universal tool stand within rooms (do not 
drag it along the ground).

If being transported in a vehicle, remove the electric power 
tool first. 
Fold up the legs for transport. 
Ensure that the load is well secured if transporting the universal 
tool stand in a motor vehicle.