22 GB/IE/NI
Use the hex key
[
31]
to loosen the screw
[
37]
in
a counter-clockwise direction .
Remove the old sanding pad
[
2]
.
Align the centre hole
[
39]
of the new sanding
pad with the spindle
[
40]
.
Place the washer
[
38]
on the thread of the
screw
[
37]
.
Use the hex key
[
31]
to fasten the screw
[
37]
in
clockwise direction .
Replacing the carbon brushes
(Fig . S)
m
WARNING!
u
Always replace both carbon brushes at the
same time .
u
Do not use accessories not recommended
by Parkside . Using incompatible carbon
brushes may result in electric shock,
personal injury or property damage .
Use the slotted screwdriver
[
32]
to loosen the
carbon brush holder cap
[
6]
in a counter-
clockwise direction .
Remove the carbon brush holder cap
[
6]
. The
spring of the carbon brush comes out .
Remove the carbon brush .
Insert the spare carbon brush
[
34]
into the
carbon brush holder .
Gently compress the spring of the carbon
brush
[
34]
using the carbon brush holder
cap
[
6]
until the spring is completely pushed
inside .
Use the slotted screwdriver
[
32]
to fasten the
carbon brush holder cap
[
6]
in clockwise
direction .
Repeat for the second carbon brush
[
34]
on
the other side .
Repair
This product does not contain any parts that can
be repaired by the user . Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired .
m
WARNING! RISK OF INJURY!
u
If the power cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard .
Storage
Switch off the product and disconnect it from
the mains . Let the product cool down .
Clean the product as described before .
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place .
Always store the product in a place that is
inaccessible to children . The ideal long term
storage (longer than 3 months) temperature
is b10 and +30 °C with a relative
humidity of max . 60 % .
Transportation
Switch off the product and disconnect it from
the mains . Let the product cool down .
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles .
Secure the product to prevent it from slipping
or falling over .
Summary of Contents for PWDS 920 B2
