Parkside PWS 1200 - 2, Operation And Safety Notes

12  GB/IE/CY

 Switching on and off

Check the attached consumable or tool before use. 
It must be attached properly, not damaged, damp 
or cracked and must rotate freely. Test the opera-
tion of the device for 30 seconds. If a disc is not 
round or vibrates, do not use it.
Look out for unusual noises or generation of sparks. 
Check that all the fastenings are correctly attached.

The device is fitted with an IPC electronic start-up 
system. After you press the ON/OFF switch 

3

there is a delay before the motor starts. 

Switching on:

j

   Press the ON/OFF switch 

3

.

Switching off:

j

   Release the ON/OFF switch 

3

 again.

Locking:

j

   Press the lock button 

1

 whilst pressing and 

holding down the ON/OFF switch 

3

.

Releasing the lock:

j

    Press the ON/OFF switch 

3

 again.

m

 Attention:

 Wait until the electric motor has 

come to a complete standstill before you press the 
spindle lock button 

10

.

 Setting the speed

j

   To increase the speed, turn the rotation speed 

preselector wheel 

11

 towards the 6 (6 = high-

est speed) setting.

j

   To decrease the speed, turn the rotation speed 

preselector wheel 

11

 towards the 1 (1 = low-

est speed) setting.  

 Changing a disc

J

   Always wear protective gloves when 

changing cutting or roughing/grind-
ing discs.

j

   Press the spindle lock button 

10

 only after the 

mounting spindle 

8

 has reached a standstill, 

Fig. B.

j

   Press the spindle lock button 

10

 to block the 

drive.

j

   Release the clamping nut 

7

 using the spanner 

12

, Fig. C.

j

   Place the roughing, grinding or cutting disc on 

to the mounting flange 

9

 with its labelled side 

facing towards the device.

j

   Then replace the clamping nut 

7

, with its 

raised side facing upwards, on to the mounting 
spindle 

8

.

j

   Press the spindle lock button 

10

 to block the 

drive.

j

   Tighten the clamping nut 

7

 again with the 

spanner 

12

.

Note:

 Replace a new disc immediately if it 

runs unevenly or vibrates after being ex-
changed.

j

   After replacing a disc let the device run under 

no load for 30 seconds as a safety check. Look 
out for unusual noises or generation of sparks. 

j

   Check that all the fastenings are correctly  

attached.

j

   Pay attention to see that the arrow showing the 

direction of rotation on the cutting or roughing/
grinding discs (including diamond cutting discs) 
corresponds with the direction of rotation of the 
device (see arrow on the head of the  
device).

Use