Parkside PWS 1200 - 2, Operation And Safety Notes

14  GB/IE/CY

Cup brush, twisted wire 
Dimensions: 

ø 75 mm

Cup brush, knotted wire
Dimensions: 

ø 115 mm

 Adjusting the disc guard cover

J

   Pull the mains plug out of the mains socket  

before you carry out any task on the device.

J

Danger of injury! 

Always use the angle 

grinder with the disc guard cover 

6

 in place. 

The disc guard cover must be securely attached 
to the angle grinder. To ensure the highest level 
of safety while using the device,  
ensure that the smallest possible area of the 
grinding or cutting tool is exposed to the opera-
tor at all times. The disc guard cover 

6

 is there 

to protect the operator from pieces breaking off 
and accidental contact with the grinding or cut-
ting tool. 

The disc guard cover has 5 set positions. 

j

    Turn the disc guard cover 

6

 into the desired 

position (working position).  The closed side of 
the disc guard cover 

6

 must always be facing 

the operator.

 Using the auxiliary handle

m

Attention!

 For safety reasons this device must 

always be used with the auxiliary handle 

5

 in 

place. The auxiliary handle 

5

 can be screwed on 

to the left, right or on the top of the head of the  
device.

  Maintenance and cleaning 

J

   Pull the mains plug out of the mains socket  

before you carry out any task on the device.

J

   Do not use sharp objects for cleaning the  

device. Do not allow any liquids to enter the 
device. 

j

   Have the carbon brushes replaced only at the 

service centre or an accredited electrical equip-
ment repair centre. The device requires no oth-
er maintenance.

j

   Clean the device frequently; for best results do 

this immediately after you have finished using it.

j

   Use a dry cloth to clean the housing – under 

no circumstances use petrol, solvents or clean-
ing agents that attack plastic. 

j

   A vacuum cleaner is required to thoroughly 

clean the device.

j

   Ventilation openings must always be kept free.

j

   Remove any adhering dust with a narrow paint 

brush.

Disposal

   The packaging is wholly composed of en-

vironmentally-friendly materials that can be 
disposed of at a local recycling centre.

Do not dispose of electrical  
power tools with the household 
rubbish!

In accordance with European Directive 
2002 / 96 / EC (covering waste electrical and elec-
tronic equipment) and its transposition into national 
legislation, worn out electrical power tools must be 
collected separately and taken for environmentally 

Use of accessories / Maintenance and cleaning / Disposal