Parkside PWS 125 C3, Original Instructions Manual

11

GB IE

NI

Additional safety instructions

•  Connect the appliance only to a power 

socket with a residual current circuit 

breaker of rated residual current no 

more than 30 mA.

•  Keep power cords and extension cords 

away from the disc. If they are damaged 

or cut through, immediately pull the plug 

from the outlet. Do not touch the cable 

before it has been disconnected from the 

power supply. Risk of electric shock!

•   The replacement of the plug or the con-

nection line must always be executed 

by the manufacturer of the electric tool 

or his/her customer service in order to 

avoid any hazards.

•  Only use grinding discs where the in-

dicated rotational speed is at least as 

high as what has been specified on the 

name plate of the device.

•  Carry out a visual inspection of the 

grinding disc before use. Do not use 

any damaged or deformed grinding 

discs. Replace any damaged or worn 

grinding discs.

•  Make sure that the sparks produced by 

grinding do not present a danger, e.g. 

reach people or ignite flammable subs

-

tances.

•  Always wear safety goggles, safety 

gloves, respiratory protection and ear 

protection when grinding, brushing and 

cutting.

•  Never keep the fingers between the 

grinding disc and spark protection or in 

close proximity to the protective hoods. 

There is a risk of crushing.

•  The rotating parts of the device cannot 

be covered due to functional reasons. 

Therefore, proceed cautiously and hold 

the workpiece firmly in order to avoid 

slipping which could cause your hands to 

come into contact with the grinding disc.

•  The workpiece gets hot during grin-

ding. Do not touch the machined area, 

allow it to cool down. There is a risk of 

burning. Do not use coolants or the like.

•  If you are tired or have consumed al-

cohol or tablets, do not work with the 

device. Always have a break on time.

•  Switch the device off and remove the 

mains plug

-  to loosen a blocked insertion tool,

-  if the connection line is damaged or 

entangled,

-  in case of unusual sounds.

RESIDUAL RISKS

Even if properly operating and handling 

this electric tool, some residual risks will 

remain. Due to its construction and build, 

this electric tool may present the following 

hazards:

a)  Lung damage if suitable respiratory pro-

tection is not worn. 

b)  Hearing damage if suitable ear protec-

tion is not worn.

c)  Damage to health due to 

-  touching the area of the grinding tool 

which is not covered;

-  ejection of parts of workpieces or 

damaged grinding discs.

d)  Health injuries which result from swin-

ging hand and arm, in the eve

nt that 

the device is used over a longer period 

of time or is not used and maintained 

properly.

Warning! 

During operation, this 

electric tool generates an electro-

magnetic field which, under certain 

circumstances, may impair the func-

tionality of active or passive medical 

implants. To reduce the risk of seri-

ous or lethal injuries, we recommend 

that persons with medical implants