PWSA 20-Li A1
GB
│
MT
│
31
■
♦
Lock the mounting spindle .
♦
Tighten the clamping nut in a clockwise di-
rection using the two-hole mounting spanner .
NOTE
►
If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦
For safety's sake run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦
Check whether all the fastening elements are
correctly fitted.
♦
Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grinding
discs (including diamond cutting discs) and the
direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
Use
Switching on and off
Check the attached tool before use to ensure that
all fastening elements are correctly fitted.
NOTE
►
Always switch on the angle grinder before
making contact with the material, then apply
it to the workpiece.
Switching on:
♦
Press the safety lock-out (see fig. E).
♦
Then press the ON/OFF switch .
Switching off:
♦
Let go of the ON/OFF switch .
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The cordless angle grinder is maintenance-free.
■
Do not use any sharp objects to clean the
appliance. Never permit liquids to enter in-
side the appliance.
Otherwise the appliance
could be damaged.
■
Clean the appliance regularly, preferably imme-
diately after completion of the work.
■
Clean the housing with a dry cloth – do NOT
use petrol, solvents or cleaners which can attack
the plastic.
■
A vacuum cleaner is required for thorough
cleaning of the appliance.
■
Ventilation openings must never be obstructed.
■
Remove any sanding dust stuck to the appliance
with a brush.
NOTE
►
Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
