EN
1. Remove the tubes (
A
), inside struts with wheel collars (
B
) and screws (
C
)
from the fi xed left and right struts.
2. Install the wheels (
D
), inside struts with wheel collars, tubes, and screws
on the retract struts (
E
).
3. Install the included left and right retract struts in the optional retracts (
F
)
using the set screws (
G
).
4. Remove 3 screws (
H
), the fi xed landing gear cover (
I
), 4 screws (
J
) and the
fi xed gear mount (
K
) from each engine nacelle.
5. Install the retracts (
L
) in the wing using 8 screws (
M
) (4 per side) removed
from the fi xed gear mounts.
6. Connect two servo extensions (PKZ5403) (
N
) to the retract and push the
extension connectors through the channels in the wing and out the holes
used by the aileron connectors.
Tip:
Ensure the extended landing gear wheels have no toe-in or toe-out for
proper ground handling.
7. Install the retract covers (
O
) on the nacelles by using the 6 screws from the
fi xed landing gear covers.
8. Connect the servo extension connectors to a Y-harness in the fuselage.
9. Connect the Y-harness to the GEAR channel of the receiver.
10. Do a control test of the retracts using your transmitter. During operation,
adjust parts so the retracts are not blocked. Tighten the screws in the
wheel collars, using threadlock when needed.
E-fl ite Retractable Landing Gear
OPTIONAL
(EFLG100,
sold separately
)
A
B
C
D
E
Fixed Landing Gear
Retractable Landing Gear
We recommend installing the E-fl ite electric retracts (optional) in the wing
before installing the wing on the fuselage.
F
G
H
I
J
K
L
M
N
O
6
