8
EN
The CG location is
22–25mm
back from the
leading edge of the wing at the fuselage.
This CG location has been determined with
the included 1S 150mAh 3.7V Li-Po battery
installed in the front of the battery cavity.
The battery cavity is oversized to allow for
Center of Gravity adjustment. Start by placing
the battery in the front of the cavity and
adjust as needed.
Adjusting Center of Gravity (CG)
22–25mm
Control Rates
We recommend using a
DSM2/DSMX
aircraft
transmitter. Adjust according to individual
preferences after initial fl ight.
It is normal for linear servos to make noise.
The noise is not an indication of a faulty servo.
To achieve the proper Low Rate settings when
using a programmable
DSM2/DSMX
aircraft
transmitter, set the Low Rate value to 70% for
aileron, elevator and rudder.
High Rate
Low Rate
Aileron
6mm up/down
4mm up/down
Elevator
5mm up/down
4mm up/down
Rudder
9mm left/right
6mm left/right
Note:
All control surfaces are measured at the
widest point.
An additional decal sheet has been included
in the box to personalize your model with
your favorite racing number.
Apply these decals in any location you may
choose.
NOTICE:
Be sure to balance your model and
fi nd the correct center of gravity after apply-
ing the decals. Decal application can aff ect
center of gravity.
Model Decals
