7
RTF
®
Binding is the process of programming the receiver of the control unit to recognize the GUID
(Globally Unique Identifi er) code of a single specifi c transmitter. You need to ‘bind’ your chosen
Spektrum DSM2 technology equipped aircraft transmitter to the receiver for proper operation.
To bind or re-bind your T-28 to your chosen transmitter please follow the directions below:
Your T-28 RTF transmitter comes pre-bound to the aircraft, so binding should not be necessary.
All that is needed to begin fl ying is installation of fully charged batteries in the aircraft
and transmitter.
Installing Transmitter Battery
3
4
1
2
6
5
7
The T-28 requires a DSM2 transmitter. The list below is Spektrum
™
or JR
®
DSM2-equipped
transmitters that can bind to the T-28. (If your transmitter is not listed, please contact Horizon Hobby):
• E-fl ite MLP4DSM
• E-fl ite LP5DSM
• ParkZone Vapor® Transmitter
• JR X9503
• ParkZone Ember® 2 Transmitter
• JR 12X 2.4
• JR X9303 2.4
• HP6DSM
• Spektrum DX5e
• Spektrum DX6i
• Spektrum DX7/DX7se
9
Binding Procedure Reference Table
1. Refer to your transmitter’s unique instructions for binding to a
receiver.
2. Make sure the fl ight battery is disconnected from the airplane.
3. Power off the transmitter.
4. Connect the fl ight battery in the aircraft. The receiver LED will
begin to fl ash. (Typically after 5 seconds).
5. Put your transmitter into bind mode. If using the MLP4DSM
transmitter, push the left control stick vertically into the case
until it clicks, while powering on the transmitter.
6. Make sure transmitter controls are neutral and throttle is in
low position.
Prior to each fl ight, power on your transmitter and wait about 5 seconds before you plug the
fl ight battery into the receiver. This allows time for the transmitter to scan and secure two
open frequencies. If you plug the fl ight battery in too quickly and miss the link, the receiver
may inadvertently enter bind mode. If this occurs leave the transmitter on, then disconnect and
reconnect the fl ight battery. Avoid binding multiple transmitters and receivers simultaneously,
binding near large metal objects (furniture, vehicles, etc.), and binding with the transmitter too
near the aircraft. Please bind the transmitter at least 50 cm from aircraft.
Transmitter and Receiver Binding
Additional Binding Information
List is complete as of this printing. Additional compatible transmitters may be available.
EN
